Husqvarna 327HDA65X, 327HE3X, 327HE4X manual KEY to Symbols

Page 2

KEY TO SYMBOLS

Symbols

WARNING! Incorrect or careless use of a hedge trimmer can turn it into a dangerous tool that can cause serious or even fatal injury. It is extremely important that you read and understand the contents of this operator’s manual.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

• Approved hearing protection

• Approved eye protection

This product is in accordance with applicable EC directives.

Cutting tool. Do not touch the tool without first switching off the engine.

This machine is not electrically insulated. If the machine

touches or comes close to high- voltage power lines it could lead

to death or serious bodily injury. Electricity can jump from one point to another by arcing. The

higher the voltage, the greater the distance electricity can jump. Electricity can also travel through branches and other

objects, especially if they are

wet. Always keep a distance of at least 10 m between the machine and high-voltage power lines and/or any objects that are touching them. If have to work within this safe distance you should always contact the relevant power company to make sure the power is switched off before you start work.

This machine can be dangerous! The operator of the machine must ensure, while working, that no persons or animals come closer than 15 metres.

Arrows which show limits for handle positioning.

Always wear approved protective gloves.

Wear sturdy, non-slip boots or shoes.

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is specified in chapter Technical data and on label.

Other symbols/decals on the machine refer to special certification requirements for certain markets.

The engine is switched off by moving the stop switch to the stop position. CAUTION! The stop switch

automatically returns to the start position. In order to prevent unintentional starting, the spark plug

cap must be removed from the spark plug when assembling, checking and/or performing maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

2 – English

Image 2
Contents 327HDA65X-series EnglishKEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchHand guard MufflerBlade guard Gear housingBlades 327HDA65Fitting the handle AssemblyFitting the hand guard and loop handle Fitting the cutting head327HE4 Adjusting the harnessFitting the impact guard Fuel Fuel safetyFuel Handling Fuelling MixingStarting and stopping Starting and StoppingCheck before starting StartingStopping Working Techniques Safety instructions regarding the surroundingsSafety instructions while working General working instructionsChanging the hedge trimmer angle Safety instructions after completing workBasic working techniques Transport position Muffler MaintenanceCarburettor Cooling system Spark plugAir filter Gear housingCleaning the air filter Oiling the air filterCleaning and lubrication Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataEC-declaration of conformity Applies to Europe only Page Page 1151377-26