Assembly

Assembling the J-handle

Assembling the transport guard

!WARNING

Only grass blades or trimmer heads/ plastic blades may be used when the J- handle is fitted. Clearing blades must never be used with the J-handle.

•Fit the handle using the 4 screws about 30 cm in

front of the throttle lever on the shaft. See the arrow mark on the shaft.

•Finely adjust the J-handle

1)Insert the tips of the blade into the grooves in the transport guard

(A).

2)Wind the guard around the blade, then snap the hook (B) to secure the transport guard.

to give a comfortable working stance. Tighten the knob.

Assembling the blade guard and grass blade

Assembly of the blade and trimmer head

It is extremely important that the disc drive’s/support flange’s guide engages correctly in the cutting equipment’s centre hole when assembling the cutting equipment. Cutting equipment assembled incorrectly can result in serious and/or fatal personal injury.

!Under no circumstances may the cutting equipment be used without an approved guard fitted. See the chapter “Technical data”. If the wrong guard or a defective guard is fitted this can cause serious personal injury.

•Fit the guard (A) to the gear housing using the support plate (M) and two screws (L).

•Fit the drive disc (B) on the output axle.

•Turn the blade axle until one of the holes in the drive disc aligns with the hole in the gear housing.

•Insert the locking pin (C) in the hole so that the axle is locked.

•Place the blade (D), support cup (F) and support flange (E) on the output shaft.

•Fit the nut (G). The tightening torque of the nut is 35-50 Nm (3,5 - 5 kpm). Use the socket spanner in the tool kit. Hold the handle of the spanner as close to the blade guard as possible. The nut is tightened when the spanner is turned against the direction of rotation (left-hand thread).

14 – English