ASSEMBLY
Assembling other guards and cutting equipment
Assembling the flexible shaft
1) Remove the screw and |
•Fit the guard (A) to the gear housing using the support plate (M) and two screws (L).
•Fit the disc drive (B) on the output axle.
•Turn the blade axle until one of the disc drive’s holes aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) into the hole to lock the axle.
•Screw on the trimmer head (H) in the direction of rotation.
•Dismantling takes place in the reverse order.
L |
M |
A |
H |
insert the outer fitting |
(with |
joint pipe (A), and tighten the screw.
2)Insert the outer fitting into the clutch case with
pulling up the pin (B). Be sure pin returns to original position by spring and outer fitting never comes off from clutch case.
Connecting throttle cable and stop switch wires
1) Insert the throttle cable through the cable adjuster sleeve on the carburettor bracket. Make sure the end of the throttle cable housing is seated positively in the sleeve.
2) Position the slotted fitting on the carburettor so the recessed hole (A) is away from the cable adjuster sleeve.
Assembling the spray guard
(Install the cord cutter and guard extension to the spray guard.)
1)Fasten the cord cutter
(A) to the spray guard
with two M5 x 25 screws, lock washers and hex nuts as shown.
2) Attach the guard extension (B) to the guard with the five M5 x 25 screws, washers and hex nuts as shown.
3) Rotate the carburettor throttle cam and slip the throttle cable through the slot in the slotted fitting, making sure the cable lug drops into the recessed hole.
4) Operate the throttle trigger a few times to make sure that it works correctly.
5) Plug the stop switch wires into the matching connectors from the engine. Note that wire polarity is not important.
6) Bind the throttle cable and the flexible shaft with two bands (B).
English – 15