Vibration damping system, Quick-release, Muffler

SAFETY INSTRUCTIONS

4.Vibration damping system

Your machine is equipped with a vibration damping system, which is designed to give as vibration-free and comfortable use as possible.

The use of blunt or incorrect cutting equipment (the wrong type or incorrectly sharpened, see the section “Sharpening the blade“ ) increases the level of vibration.

The machine’s vibration damping system reduces the transfer of vibrations between the engine unit/ cutting equipment and the machine’s handle unit.

!WARNING!

Over exposure to vibrations can result in blood-vessel or nerve injury to persons suffering with blood circulation problems. Seek medical attention if you experience physical symptoms that can be related to over exposure to vibrations. Examples of such symptoms are “numbness“, lack of feeling, “tickling“, “pricking“, “pain“, lack of or a reduction in normal strength, changes in the colour of the skin or its surfaces. These symptoms normally appear in the fingers, hands or wrists.

5.Quick-release

There is an easily accessible, quick-release catch fitted to the chest as a safety precaution in the event of a fire in the engine or for any other situation that requires you to free yourself from the machine and harness. See the section “Adjusting the harness and brush cutter“.

6. Muffler

The muffler is designed to give the lowest possible noise level and to direct the engine‘s exhaust fumes away from the operator. .

In countries that have a warm and dry climate the risk of fire is obvious. We have therefore fitted certain mufflers with a spark arrestor screen. Make sure that your muffler is fitted with this kind of screen.

It is extremely important that the instructions for checking, maintaining and servicing the muffler are followed. (see the section “Control, maintenance and service of the machine‘s safety equipment“).

!WARNING!

Bear in mind that exhaust fumes:

•contain carbon monoxide, which can cause carbon monoxide poisoning. Therefore never start or run the machine indoors.

•are hot and can contain sparks that can cause fires. Never start the machine indoors or close to inflammable material.

7.Cutting1

equipment

1)Grass blades are intended for brush cutting.

2) The trimmer head is	2
intended for trimming
grass.

8. Locking nut

A locking nut is used to secure some types of cutting equipment on the output shaft.

English – 5