Ryobi RY44140 manuel dutilisation Operation

OPERATION

WARNING:

Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to comply with ANSI Z87.1. Wear head protection when operating this equipment above shoulder level. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries.

WARNING:

Do not use any attachments or accessories not recom- mended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury.

APPLICATIONS

You may use this product for the purpose listed below:

nTrimming and shaping hedges and shrubbery

Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please call 1-800-860-4050 or contact an authorized service center for assistance.

INSTALLING DEBRIS DEFLECTOR

See Figure 3.

NOTE: Always wear non-slip, heavy-duty gloves when in- stalling or removing the debris deflector.

Disconnect the plug from the power source.

Place the hedge trimmer on a sturdy flat surface.

Align the angled edge of the debris deflector with the grooves on the guide bar.

Slide the deflector completely onto the guide bar so the angled edge of the deflector rests beneath the guard.

Insert the deflector retainer in the end of guide bar.

WARNING:

Never use the debris deflector as a handle or attempt to hold or guide the hedge trimmer by gripping the debris deflector. Always keep both hands on the hedge trimmer handles. Improper handling of hedge trimmer could result in serious injury.

CONNECTING TO POWER SUPPLY

See Figure 4.

This product is designed with a cord retainer that prevents the extension cord from being pulled loose while using.

nForm a loop with the end of the extension cord.

nInsert loop portion of extension cord through opening in the bottom of the rear handle and place over cord retainer.

nSlowly pull loop against cord retainer until the slack is removed.

nPlug product into extension cord.

NOTE: Failure to remove all excess cord slack from ex- tension cord retainer could result in plug loosening from receptacle.

STARTING AND STOPPING

See Figure 5.

Attach the outlet end of an extension cord to the plug on the rear of the hedge trimmer. Route extension cord through cord retainer as shown on the next page.

NOTE: Use only an approved outdoor extension cord as described previously in this manual.

Grasp the front handle with your left hand and the rear handle with your right hand.

The front handle switch and the switch trigger must be

depressed­ simultaneously to begin blade rotation.

To stop blade rotation, release the switch ­trigger.

ROTATING HANDLE

See Figure 6.

The handle can be rotated 45° or 90° to the left or to the right.

To rotate handle:

Disconnect the plug from the power source.

Pull back on the rotating handle knob.

Turn handle to the right or to the left.

Release rotating handle knob.

Keep turning handle until it locks into place in one of the 45° or 90° positions.

NOTE: The trimmer will only operate at one of these locked positions. The handle is locked when the rotating handle knob is securely in place, is not extended, and the handle will no longer move to either side.

Page 9 – English