Ryobi 767r, 775r HOT Surface Warning, Sharp Blade Do not USE Blades Indicates OIL, Choke Control

Page 7

RULES FOR SAFE OPERATION

SYMBOL

MEANING

•THROWN OBJECTS AND ROTATING CUTTER CAN

CAUSE SEVERE INJURY

WARNING: Do not operate without the cutting attachment shield in place. Keep away from the rotating cutting attachment.

•ON/OFF STOP CONTROL

ON / START / RUN

•ON/OFF STOP CONTROL

OFF OR STOP

•HOT SURFACE WARNING

Do not touch a hot muffler or cylinder. You may get burned. These parts get extremely hot from operation. When turned off they remain hot for a short time.

•SHARP BLADE

WARNING: There is a sharp blade on the cutting attachment shield. To prevent serious injury, do not touch blade.

•DO NOT USE BLADES

WARNING: To prevent serious injury, do not attach or operate the unit with any type of blade.

•INDICATES OIL

Refer to operator's manual for the proper type of oil.

• CHOKE CONTROL

A • FULL CHOKE position.

B • PARTIAL CHOKE position.

C • RUN position.

WARNING: The operation of any power tool can cause foreign objects to be thrown into your eyes. This can lead to severe eye damage. Before commencing power tool operation, always wear safety glasses or goggles that are marked as meeting ANSI Z87.1-1989 standards, and a full face shield when needed.

7

Image 7

Contents OPERATOR’S Manual Introduction Table of ContentsSpark Arrestor California Emission RegulationsRules for Safe Operation Symbol MeaningWhile Operating Keep Bystanders Away Primer Bulb Safety and International SymbolsSymbol Meaning Safety Alert Symbol For Service INFORMATION, CallFull Choke position Partial Choke position HOT Surface WarningSharp Blade Do not USE Blades Indicates OIL Choke ControlKnow Your Unit Application Shaft Housing Throttle Control Handle HardwareModel 767r Assembly InstructionsInstalling and Adjusting the D-HANDLE Model 767r Wing Nut Bolt WasherDecal Installing and Adjusting the J-HANDLE Model 775rHandle Screws Top Clamp Middle Clamp Bottom Clamp Model 775rCutting Attachment Shield Recessed Holes Installing the Cutting Attachment ShieldShaft Housing Cutting Shield MountOIL and Fuel Mixing Instructions Using Blended FuelsUsing Fuel Additives OIL and Fuel InformationStarter Rope Throttle Control STARTING/STOPPING InstructionsPartial Choke Position B Full Choke Run Position a Choke Lever Primer BulbSystem Model 775r Installing the Cutting Attachment or Add-OnsOperating Instructions Operating the CLICK-LINKModel 767r Model 775r Holding the Trimmer Adjusting Trimming Line LengthMaintenance and Repair Instructions Winding the Inner Reel With New Line Line Installation for the SpeedspoolBump Knob Foam Seal Spring Inner Reel Installing a Prewound Inner reelCleaning the SpeedSpool Releasing the Inner ReelChoke Lever Partial Choke Position B Screws AIR Filter MaintenanceRemoving the Air Filter/Muffler Cover Shaft PlungerReinstalling the Air filter/Muffler Cover Cleaning the Air FilterAir Filter Check Fuel Mixture Carburetor AdjustmentClean Air Filter Adjust Idle Speed Screw020 ACCESSORIES/REPLACEMENT PartsReplacing the Spark Plug 110-120 in.lb .3-13.5 NmLong Term Storage Cleaning and StorageCleaning StorageProblem Cause Action TroubleshootingEngine SpecificationsDrive Shaft & String Head Page Owners Warranty Responsibilities Ryobi Canada INC Ryobi Outdoor Products