MAINTENANCE AND REPAIR INSTRUCTIONS
8.Hold the outer spool. Wind the inner reel counterclockwise until approximately four (4) inches (102 mm.) of line remain (Fig. 24).
NOTE: Do not wind the inner reel before installing the second piece of line.
3.Insert the ends the of line into the outer spool eyelets (Fig. 27). Push the new inner reel, arrow side up, into the outer spool.
Fig. 24
9.If winding the line becomes difficult or the line jams, pull the ends of the line from the spool (Fig. 25). Continue winding the inner reel counterclockwise .
Fig. 25
Installing a Prewound Inner reel
1.Remove the bump knob, spring, and foam seal by turning the Bump Knob counterclockwise (Fig. 26).
Bump Knob 
Foam Seal
Spring
Inner Reel 
Fig. 26
2.Pull the old inner reel with existing line from the outer spool.
Fig. 27
4.Hold the inner reel in place and install the bump knob, spring and foam seal by pressing down and turning the bump knob clockwise. Grasp the ends and pull firmly to release the line from the holding slots in the inner reel. (Fig. 25).
Releasing the Inner Reel
If the SpeedSpool® does not release line correctly, pull the ends of the line firmly from the spool (Fig. 25). If this does not release line, follow the Cleaning the SpeedSpool® instructions below.
Cleaning the SpeedSpool®
Cleaning the SpeedSpool® may be necessary,
•To remove jammed or excess line,
•If the SpeedSpool® becomes difficult to wind or does not operate correctly when bumping the head on the ground,
1.Hold the outer spool, and unscrew the bump knob counterclockwise (Fig. 28).
Fig. 28
2.Pull out the bump knob, spring, and foam seal (Fig. 26).
18