Ryobi 767r manual Operating Instructions, Operating the CLICK-LINK, System Model 775r

OPERATING INSTRUCTIONS

OPERATING THE CLICK-LINK®

SYSTEM - MODEL 775r

The model 775r Click-Link®system enables the use of these optional add-ons.

Blower/Vacuum . . . . . . . . . . . . . . . . . . BV720r Cultivator . . . . . . . . . . . . . . . . . . . . . . . GC720r Edger . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r Hedgetrimmer . . . . . . . . . . . . . . . . . . . HS720r Snowthrower . . . . . . . . . . . . . . . . . . . . ST720r Straight Shaft Trimmer . . . . . . . . . . . . . SS725r Sweeper/Blower . . . . . . . . . . . . . . . . . . SB720r Tree Pruner . . . . . . . . . . . . . . . . . . . . . . TP720r Turbo Blower . . . . . . . . . . . . . . . . . . . . TB720r

WARNING: Read and understand operator’s manual for add-on prior to operation.

Removing the Cutting Attachment or Add-Ons:

1.Turn the knob counterclockwise to loosen (Fig. 13).

2.Press and hold the release button (Fig. 13).

3.While firmly holding the upper shaft housing, pull the cutting attachment or add-on straight out of the Click-Link®coupler.

Installing the Cutting Attachment or Add-Ons:

WARNING: To avoid serious personal injury, shut unit off before removing or installing add-ons.

NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench.

1.Turn the knob counterclockwise to loosen (Fig. 13).

Click-Link®Coupler Release Button

Knob

Guide Recess

Fig. 13

2.While firmly holding the add-on, push it straight into the Click-Link®coupler (Fig. 14).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 14).

Click-Link®Coupler

Primary Hole

Release Button

Upper Shaft Housing Lower Shaft Housing

Fig. 14

3.Turn the knob clockwise to tighten (Fig. 15).

CAUTION: Lock the release button in the primary hole and securely tighten the knob before operating this unit.

90˚ Edging Hole

Knob

180˚ Edging Hole

Fig. 15

CAUTION: The cutting attachment and add-ons with the Click-Link®system are to be used in the primary hole unless stated otherwise in the specific add-ons operator’s manual. Using the wrong hole could lead to personal injury, or damage to the unit.

For edging with Click-Link®models, lock the release button of the cutting attachment into the 90° edging hole or the 180° edging hole

(Fig. 15).

14