Ryobi 767r, 775r manual California Emission Regulations, Spark Arrestor

Page 3

CALIFORNIA EMISSION REGULATIONS

This unit meets the 1995 to 1998 California emissions regulations for small off-road engines. These units are identified by the label on the engine of your product. A typical identification label is shown.

To ensure that your unit continues to meet these regulations, refer to the following information and instructions in this operator’s manual.

California Proposition 65 Warning:

WARNING

THE ENGINE EXHAUST FROM THIS

PRODUCT CONTAINS CHEMICALS

KNOWN TO THE STATE OF

CALIFORNIA TO CAUSE CANCER,

BIRTH DEFECTS OR OTHER

REPRODUCTIVE HARM.

SPARK ARRESTOR

NOTE: For users on U.S. Forest Land and in the states of California, Maine, Oregon and Washington. All U.S. Forest Land and the states of California (Public Resources Codes 4442 and 4443), Oregon and Washington require, by law that certain internal combustion engines operated on forest brush and/or grass- covered areas be equipped with a spark arrestor, maintained in effective working order, or the engine be constructed, equipped and maintained for the prevention of fire. Check with your state or local authorities for regulations pertaining to these requirements. Failure to follow these requirements could subject you to liability or a fine. This unit is not factory equipped with a spark arrestor. If these items are required in your area, ask your LOCAL SERVICE dealer to install the Optional Accessory Part #180030 Spark Arrestor Kit.

WARNING!

Read the Operator’s Manual(s) and follow all warnings and safety instructions. Failure to do so can result in serious injury to the operator and/or bystanders.

FOR QUESTIONS, CALL 1-800-345-8746 IN U.S. OR 1-800-265-6778 in CANADA

3

Image 3
Contents OPERATOR’S Manual Introduction Table of ContentsSpark Arrestor California Emission RegulationsRules for Safe Operation Symbol MeaningWhile Operating Keep Bystanders Away Primer Bulb Safety and International SymbolsSymbol Meaning Safety Alert Symbol For Service INFORMATION, CallFull Choke position Partial Choke position HOT Surface WarningSharp Blade Do not USE Blades Indicates OIL Choke ControlKnow Your Unit Application Shaft Housing Throttle Control Handle HardwareModel 767r Assembly InstructionsInstalling and Adjusting the D-HANDLE Model 767r Wing Nut Bolt WasherDecal Installing and Adjusting the J-HANDLE Model 775rHandle Screws Top Clamp Middle Clamp Bottom Clamp Model 775rCutting Attachment Shield Recessed Holes Installing the Cutting Attachment ShieldShaft Housing Cutting Shield MountOIL and Fuel Mixing Instructions Using Blended FuelsUsing Fuel Additives OIL and Fuel InformationStarter Rope Throttle Control STARTING/STOPPING InstructionsPartial Choke Position B Full Choke Run Position a Choke Lever Primer BulbSystem Model 775r Installing the Cutting Attachment or Add-OnsOperating Instructions Operating the CLICK-LINKModel 767r Model 775r Holding the Trimmer Adjusting Trimming Line LengthMaintenance and Repair Instructions Winding the Inner Reel With New Line Line Installation for the SpeedspoolBump Knob Foam Seal Spring Inner Reel Installing a Prewound Inner reelCleaning the SpeedSpool Releasing the Inner ReelChoke Lever Partial Choke Position B Screws AIR Filter MaintenanceRemoving the Air Filter/Muffler Cover Shaft PlungerCleaning the Air Filter Reinstalling the Air filter/Muffler CoverAir Filter Check Fuel Mixture Carburetor AdjustmentClean Air Filter Adjust Idle Speed Screw020 ACCESSORIES/REPLACEMENT PartsReplacing the Spark Plug 110-120 in.lb .3-13.5 NmLong Term Storage Cleaning and StorageCleaning StorageProblem Cause Action TroubleshootingSpecifications EngineDrive Shaft & String Head Page Owners Warranty Responsibilities Ryobi Canada INC Ryobi Outdoor Products