Ryobi 767r, 775r Installing the Cutting Attachment Shield, Shaft Housing Cutting, Shield Mount

Page 11

ASSEMBLY INSTRUCTIONS

INSTALLING THE CUTTING

ATTACHMENT SHIELD

Use the following instructions if the cutting attachment shield on your unit is not installed.

WARNING: Never operate the trimmer without the cutting attachment shield in place to prevent serious personal injury.

1.Slide the cutting attachment shield into the shield mount on the cutting attachment. Align the screw holes in the shield with the holes in the cutting attachment (Fig. 7).

Shaft Housing	Cutting
	Attachment Shield

Shield Mount

Cutting Attachment

Fig. 7

2.Place a hex lock nut into one of the three recessed holes on the top of the cutting attachment shield (Fig 8).

Cutting Attachment Shield

Recessed Holes

Hex Lock Nut

Fig. 8

3.Install a screw into the hole from the bottom of the cutting attachment shield and screw it into the nut installed in step #2 (Fig 9). Do not tighten.

Screws

Fig. 9

4.Repeat steps 2 and 3 until all three screws have been started, then tighten securely.

Image 11

Contents OPERATOR’S Manual Introduction Table of ContentsSpark Arrestor California Emission RegulationsRules for Safe Operation Symbol MeaningWhile Operating Keep Bystanders Away Primer Bulb Safety and International SymbolsSymbol Meaning Safety Alert Symbol For Service INFORMATION, CallFull Choke position Partial Choke position HOT Surface WarningSharp Blade Do not USE Blades Indicates OIL Choke ControlKnow Your Unit Application Shaft Housing Throttle Control Handle HardwareModel 767r Assembly InstructionsInstalling and Adjusting the D-HANDLE Model 767r Wing Nut Bolt WasherDecal Installing and Adjusting the J-HANDLE Model 775rHandle Screws Top Clamp Middle Clamp Bottom Clamp Model 775rCutting Attachment Shield Recessed Holes Installing the Cutting Attachment ShieldShaft Housing Cutting Shield MountOIL and Fuel Mixing Instructions Using Blended FuelsUsing Fuel Additives OIL and Fuel InformationStarter Rope Throttle Control STARTING/STOPPING InstructionsPartial Choke Position B Full Choke Run Position a Choke Lever Primer BulbSystem Model 775r Installing the Cutting Attachment or Add-OnsOperating Instructions Operating the CLICK-LINKModel 767r Model 775r Holding the Trimmer Adjusting Trimming Line LengthMaintenance and Repair Instructions Winding the Inner Reel With New Line Line Installation for the SpeedspoolBump Knob Foam Seal Spring Inner Reel Installing a Prewound Inner reelCleaning the SpeedSpool Releasing the Inner ReelChoke Lever Partial Choke Position B Screws AIR Filter MaintenanceRemoving the Air Filter/Muffler Cover Shaft PlungerAir Filter Cleaning the Air FilterReinstalling the Air filter/Muffler Cover Check Fuel Mixture Carburetor AdjustmentClean Air Filter Adjust Idle Speed Screw020 ACCESSORIES/REPLACEMENT PartsReplacing the Spark Plug 110-120 in.lb .3-13.5 NmLong Term Storage Cleaning and StorageCleaning StorageProblem Cause Action TroubleshootingDrive Shaft & String Head SpecificationsEngine Page Owners Warranty Responsibilities Ryobi Canada INC Ryobi Outdoor Products