Ryobi 767r manual Installing and Adjusting the J-HANDLE Model 775r, Decal

ASSEMBLY INSTRUCTIONS

INSTALLING AND ADJUSTING THE J-HANDLE - MODEL 775r

1.Place the J-handle between the top and middle clamp pieces (Fig. 4).

J-Handle

(4) Screws

Top Clamp
Middle Clamp
Bottom Clamp	Nuts

Fig. 4

2.Install, one at a time, the four (4) screws and four (4) hex nuts through the top, middle and bottom clamps with a large Phillips screwdriver. Do not tighten until you make the handle adjustment.

3.Slide the J-handle out until the arrow/white line on the decal touches the clamp assembly (Fig. 5).

4.While holding the unit in the operating position (Fig. 6), position the J-handle to the location that provides you the best grip.

Model 775r

Fig. 6

5.Tighten the clamp screws evenly until the J-handle is secure.

Decal

Fig. 5

10