JVC HR-VP783U manual How to use the Remote

EN 57

Remote

1								&
2		CABLE/ MBR SET						*
	TV	DBS	A/B	POWER
3								(
4		TV/VCR A. MONITOR DISPLAY						)
5	1	2		3				q
	4	5		6			2	w
6
	DBS	DAILY(M-F)		WEEKLY				e
7	7	8		9				r
	C. RESET	AUX
		0
8	CANCEL			TIMER			4	t
9	START	STOP	DATE	CH				y
0		EXPRESS PROGRAMMING						u
	1 PROG	PROG	SP/EP	SKIP SEARCH				i
!		CHECK						o
	REW	PLAY		FF
@
		STOP		PAUSE				p
#	REC
			ENTER/O					Q
$	MENU TV CH + 3			SD
				OK
%		SHUTTLE						W
^	V	PLUS		T
	T					+
	V				L			E
	O			O
	L
	–			V
				V
		TV CH	–

MULTI BRAND

REMOTE CONTROL UNIT

The glow-in-the-dark buttons shown in white on the illustration above are helpful when using the Remote in darkened rooms.

Buttons with a small dot on the left side of the name can also be used to operate your TV while holding down TV on the Remote. ( pg. 46).

1CABLE/DBS button : pg. 47

2 TV button: pg. 46

3TV/VCR button : pg. 25, 26, 46

4 REVIEW button : pg. 24

5Number buttons : pg. 25, 30, 33

6 DBS button : pg. 35

7 CANCEL button : pg. 31, 36

C. (Counter) RESET button : pg. 22, 26

8STOP +/– button : pg. 31, 34

9 START +/– button : pg. 34

0PROG. (Program) button : pg. 30, 34 ! PROG. CHECK button : pg. 36

@ REW ( 1 ) button : pg. 21, 25, 28

# REC ( ƒ ) button : pg. 25

$ STOP ( 7 ) button : pg. 21, 25 % MENU button

^ SHUTTLE PLUS %Þ buttons

TV CH +/– buttons : pg. 46, 47, 48

&MBR SET button : pg. 46, 47, 48

A/B button : pg. 49

*POWER button : pg. 21, 25

(A. (Audio) MONITOR button : pg. 23

(TV Muting) button : pg. 46

)DISPLAY button : pg. 22, 26

qDAILY (M-F) button : pg. 31, 35 w WEEKLY button : pg. 31, 35 e AUX button : pg. 43, 45

rTIMER button : pg. 31, 35, 36 t DATE +/– button : pg. 34

yCH +/– button : pg. 25, 34

u SKIP SEARCH button : pg. 29

iSP/EP button : pg. 25, 31, 35 o PLAY ( 3 ) button: pg. 21, 25

p FF ( ` ) button: pg. 21, 25, 28

Q PAUSE ( 8 ) button: pg. 25, 29 W OK button

ENTER button : pg. 46, 47, 48

OSD button : pg. 27

E SHUTTLE PLUS 4 ¢ (@ #) button

:pg. 29

TV VOL.+/– button : pg. 46

How to use the Remote

Before use, insert two AA size batteries into the Remote with the polarity (» and Æ) matched correctly as indicated on the battery compartment or on the lid.

The Remote can operate most of your VCR’s functions, as well as basic functions of TV sets, cable boxes and DBS receivers.

Point the Remote toward the remote sensor on the target component. The maximum operating distance of the remote control is about 8 m.

NOTE:

If the Remote does not work properly, remove its batteries, wait for a few seconds, replace the batteries and then try again.