Ryobi 2075r manual Operating the CLICK-LINK System

OPERATING INSTRUCTIONS

OPERATING THE CLICK-LINK SYSTEM

This unit is equipped with a Click-Link®System, which enables optional attachments to be installed on the unit. The optional attachments are:

Blower/Vacuum. . . . . . . . . . . . . . . . . . . . . BV720r

Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . GC720r

Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r

Hedgetrimmer . . . . . . . . . . . . . . . . . . . . . HS720r

Snowthrower. . . . . . . . . . . . . . . . . . . . . . . ST720r

Straight Shaft Trimmer . . . . . . . . . . . . . . . SS725r

Sweeper/Blower . . . . . . . . . . . . . . . . . . . . SB720r

Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . TP720r

Turbo Blower . . . . . . . . . . . . . . . . . . . . . . TB720r

WARNING: To avoid serious personal injury, shut off the unit prior to removing or installing any attachments.

Removing the Lower (Attachment) Boom

NOTE: To make removing the boom easier, place the unit on the ground or on

atable.

1.Loosen the knob counterclockwise (Fig. 8).

2.Press and hold the release button in (Fig. 8).

3.While firmly holding the upper boom, pull the lower boom straight out of the Click-Link (Fig. 9).

Click-Link	Release Button
	Guide
Knob	Recess

Fig. 8

If your unit is not assembled, or you have more than one attachment, use the following instructions:

Installing the Lower (Attachment) Boom

1.Remove the hanger from the lower (attachment) boom. Hold the release button down while pushing the lower (attachment) boom into the Click-Link (Fig. 9).

2.BASIC TRIMMING OR USING OTHER RYOBI ATTACHMENTS - Locate and lock the release button into the primary hole in the Click-Link (Fig. 9).

3.EDGING WITH THE TRIMMING HEAD ATTACHMENT - Locate and lock the release button into the 90˚ edging hole or 180˚ edging hole in the Click-Link (Fig. 10).

CAUTION: Make sure the release button is locked in the primary hole and knob is securely tightened before operating this unit.

CAUTION: All attachments are designed to be used in the primary hole unless otherwise indicated in the attachment’s operator’s manual. If the incorrect hole is used, it could result in injury, or damage to the unit.

Click-Link	Primary Hole
Upper	Release	Lower
Boom	Button	Boom

Fig. 9

4.Tighten the knob securely clockwise before using the unit (Fig. 10).

90˚
Edging
Hole
	Knob
	180˚
	Edging
Washer	Hole

Fig. 10

10