TROUBLESHOOTING
PROBLEM | CAUSE | ACTION |
Engine will not start | Ignition switch is “OFF” | Turn switch to “ON” |
| Empty fuel tank | Fill fuel tank |
| Primer bulb wasn't pressed | Press primer bulb fully and slowly |
| enough | |
| Engine flooded | Use starting procedure WITHOUT |
|
| USING CHOKE |
| Old or Improperly Mixed Fuel | Drain fuel tank / Add fresh fuel |
|
| mixture |
|
|
|
Fouled spark plug | Excessive oil in oil/fuel | Replace spark plug / Drain fuel |
| mixture or Old Fuel | tank / Add fresh fuel mixture |
|
|
|
Engine will not idle | Carburetor misadjusted | Adjust carburetor |
| Old or Improperly Mixed Fuel | Drain fuel tank / Add fresh fuel |
|
| mixture |
|
|
|
Engine will not accelerate | Old or Improperly Mixed Fuel | Drain fuel tank / Add fresh fuel |
|
| mixture |
| Cutting head bound with grass | Stop engine and clean cutting head |
|
|
|
Engine lacks power or | Throttle wire has come loose | Tighten throttle wire |
stalls when cutting | Dirty air filter | Clean or replace air filter |
| ||
| No oil in fuel or Old Fuel | Drain fuel tank / Add fresh fuel |
|
| mixture |
| Carburetor misadjusted | Adjust carburetor |
| Cutting head bound with grass | Stop engine and clean cutting head |
| Muffler plugged | Clean or replace muffler (contact |
|
| authorized service dealer) |
|
|
|
Cutting head will not | Cutting head out of line | Refill with new line |
advance line | Inner reel bound up | Replace inner reel |
| ||
| Cutting head dirty | Clean inner reel and outer spool |
| Line welded | Disassemble, remove the welded |
|
| section and rewind the line |
| Line twisted when refilled | Disassemble and rewind line |
| Not enough line is exposed | Push the Bump Knob and pull out |
|
| line until 4 in (102 mm) of line is |
|
| outside of the cutting head |
|
|
|
Cutting line advances | Oil in cutting head | Clean cutting head |
uncontrollably |
|
|
|
|
|
If further assistance is required, contact your authorized service dealer.
17