OIL and Fuel Information, Definition of Blended Fuels

OIL AND FUEL INFORMATION

Old or improperly mixed fuel are usually the main reasons for the unit not running properly. Be sure to use fresh, clean fuel and follow the instructions carefully for the proper fuel/oil mixture.

NOTE: Alcohol-blended fuel absorbs moisture (water). As little as 1% moisture in the fuel can cause fuel and oil to separate and form acids when stored. If this type of fuel must be used, use fresh fuel (less than 60 days old), and mix according to the mixing instructions.

DEFINITION OF BLENDED FUELS

Today's fuels are often a blend of gasoline and one or more oxygenates such as ethanol, methanol or MTBE (ether).

USE OF BLENDED FUELS

If you choose to use a blended fuel or its use is unavoidable, the following precautions are recommended.

1.Always use fresh fuel mix per your operator's manual.

2.Use the special additive STA-BIL® or an equivalent.

3.Always agitate the fuel mix before fueling the unit.

4.Drain the tank and run the engine dry before storing the unit.

WARNING: Gasoline is extremely flammable and its vapors can explode if they are ignited. To avoid serious personal injury, always stop the engine and allow it to cool before filling the fuel tank. Do not smoke while filling the tank. Keep sparks and open flames away from the area.

WARNING: Pressure can build up in the fuel tank. Loosen the fuel tank cap slowly to relieve any pressure in the tank.

USE OF FUEL ADDITIVES

The use of fuel additive, such as STA-BIL® Gas Stabilizer or an equivalent, will inhibit corrosion and minimize the formation of gum deposits. Add 0.8 oz (23 ml) per gallon of fuel per instructions on container. NEVER add fuel additives directly to the unit's fuel tank. Using a fuel additive can keep fuel fresh for up to six

(6) months.

CAUTION: For proper engine operation and maximum reliability, pay strict attention to the oil and fuel mixing instructions on the

2-cycle oil container. Use a 32:1 fuel/oil ratio. Use 2-cycle oil. Using improperly mixed fuel can severely damage the engine.

OIL AND FUEL MIXING INSTRUCTIONS

Thoroughly mix the proper ratio of 2-cycle engine oil with unleaded gasoline in a separate fuel can, 32:1. Do not mix them directly in the engine fuel tank. See the table below for specific gas and oil mixing ratios.

UNLEADED		RYOBI OIL
GAS

1 U.S. GALLON	+	4.0 fl. oz.
(3.8 liters)	+	(118 ml)

1 LITER	+	30 ml

MIXING RATIO - 32:1