MAINTENANCE AND REPAIR INSTRUCTIONS
5.Repeat the procedure with the second eyelet and use the same amount of line as specified in Step 2.
6.Wind the inner reel counterclockwise until approximately four (4) inches of line remains outside of the eyelets in the outer spool (Fig. 17).
1.If you need to remove the Bump Knob to clean the spool or remove jammed, excess line, hold the outer spool, and unscrew the Bump Knob counterclockwise (Fig. 19).
TO INSTALL NEW TRIMMING LINE, IT IS NOT NECESSARY TO REMOVE THE BUMP KNOB.
Fig. 17
7.If winding the line becomes difficult or the line jams, pull the ends of the line away from the spool and continue winding the inner reel counterclockwise (Fig. 18).
Fig. 18
Releasing the Inner Reel
If the SpeedSpool does not operate correctly when bumping the head on the ground, use the following instructions.
Pull the ends of the line firmly away from the spool to release the inner reel (Fig. 18). If this procedure does not release the inner reel, follow the “Cleaning the SpeedSpool” instructions below.
Cleaning the SpeedSpool
If the SpeedSpool becomes difficult to wind or does not operate correctly when bumping the head on the ground, use the following instructions.
Fig. 19
2.Remove the Bump Knob, foam seal, spring, inner reel, and trimming line from the outer spool (Fig. 20).
Bump Knob
Foam Seal
Spring Assembly 
Inner Reel
Fig. 20
3.Remove any debris or grass from the knob, spring, inner reel, and foam seal. Remove any existing line from the inner reel before cleaning. Wash the inner reel with warm soapy water (Fig. 21).
Inner
Reel
Fig. 21
13