Craftsman 358.7958 manual Howto Stop Your Unit, HOW to Start Your Unit, Starting a Flooded Engine

Page 10

orlongerDrainthegastank,startthe. engineandletitrununtilthefuellines andcarburetorareemptyUsefresh. fuelnextseason. Neveruseengineorcarburetorclean- erproductsinthefueltankorperma- nentdamagemayoccur. SeetheSTORAGEsectionforaddition- alinformation.

HOWTO STOP YOUR UNIT

•To stop the engine, move the ON/ OFF switch to the OFF position.

•If engine does not stop, move choke lever to FULL CHOKE position.

ON/OFF

Throttle Trigger _ _.

HOW TO START YOUR UNIT

_WARNING:

The trimmer head

will turn while starting the engine,

Avoid any contact with the muffler. A hot muffler can cause serious burns,

STARTING A COLD ENGINE (or a warm engine after running out of fuel)

",1,@ ,J;'_

c_;artingPosition

Choke

position decal

5.Squeeze the throttle trigger fully and hold through all remaining steps.

6.Pull starter rope handle sharply until engine sounds as if it is trying

to start, but do not pull rope more than 6 times.

7.As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE by aligning lever with position shown on decal (see illustration below).

Choke

position decal

8.Pull starter rope sharply until engine runs, but no more than 6 pulls. If the engine doesn't start after 6 pulls (at

the HALF CHOKE position), move the choke lever to the FULL CHOKE

position and press the primer bulb 6 times. Squeeze and hold the throttle

t&j @

Choke

P Lever

Primer Bulb

Muffler

1.Set unit on a flat surface.

2.Move ON/OFF switch to the ON position.

3.Slowly press the primer bulb 6 times.

4.Move choke lever to FULL CHOKE by aligning lever with position shown on decal (see following illustration).

trigger and pull the starter rope 2 more times. Move the choke lever

to the HALF CHOKE position and pull the starter rope until the engine runs, but no more than 6 pulls. If the

engine doesn't start, repeat proce- dure 2 additional times.

NOTE: If engine still doesn't start, it is probably flooded. Proceed to

STARTING A FLOODED ENGINE.

9.Once the engine starts, allow it to run 10 seconds, then move the choke lever to OFF CHOKE by align- ing lever with position shown on de-

cal (see illustration below). Allow the unit to run for 30 more seconds at

OFF CHOKE before releasing the

throttle trigger. NOTE: If engine dies with the choke lever in the OFF

CHOKE position, move the choke le- ver to the HALF CHOKE position and pull the rope until engine runs, but no more than 6 pulls.

lO

Page 9 Page 11
Image 10
Page 9 Page 11
Contents €RAFTSMA#J Sears, Roebuck and Co., Hoffman Estates, IL TWO Year Full Warranty on Craftsman GAS BrushwackerAlways Wear Operator Safety UNIT/MAINTENANCE SafetyCutting Safety Fuel SafetyTransporting Storage Cartoncontents Head if not already installed Installation of the CuttingTo Relocate Shoulder Strap Attaching the Metal Shield Installation of the Metal BladeWise. Only tighten hand tight Attaching the Plastic ShieldLeavethedustcupontheshaft Before Starting Engine Know Your BrushwackerPrimer Bulb ChokeHowto Stop Your Unit HOW to Start Your UnitStarting a Flooded Engine Operating Instructions Starting a Warm EngineStarting a Flooded Engine Operating PositionScalping MowingSweeping Trimming Operating Instructions for USE with Weed BladesTask When To Perform Maintenance ScheduleMaintenance Recommended Cutting PositionInspect Muffler Spark Arresting Screen Clean AIR FilterDecals Replace Spark PlugCarburetor Adjustment Line ReplacementBlade Replacement Idle Speed AdjustmentEngine Seasonal StorageFuel System OtherTrouble Where to GET Warranty SER Your Warranty Rights and OBIs Covered Repair or Replace MAINTENANCE, Replacement and Repair of Emission RE Emission Control WarrantyAdvertencia Peligro iEsta herramienta motorizada puede ser peligrosaNo utilice el Utilice SiempreAdvertenoia Seguridad DEL OperadorSeguridad AL Cortar Seguridad CON EL CombustibleTransporte Y Almacenamiento Aviso DE Seguridad El estar ex Contenido DE LA CajaInstalacion DEL Mango MontajeHerramientas Necesarias Para Mover LA Abrazadera DE LA Correa AL HombroMontaje DE LA Cuchilla Metauca Configuracion DEL AparatoInformacion DE Montaje Cabezal DE Corte Para Instalar EL Cabezal DEMontaje DE LA Protector Metalica Para Instalar EL Protector PlasticaMontaje DE LA Cuchilla Metalica Cuchillacon Bombeador Conozca SU AparatoInterruptor ON/OFF Cebador Antes DE Poner EN Marcha EL MotorPara Poner EN Marcha EL Motor Para Detener EL MotorFull Choke Para Arrancar CON MotorOFF Choke Ranque DE Motor AhogadoPara Arrancar CON EL Motor Caliente Arranque DE Motor AhogadoCabezal DE Corte Instrucciones DE Manejo CONMetodos DE Corte Advertencia El Rebote de la Cuchilla es una Para BarrerCortadora DE Malezas Causas DEL Rebote DE LA Cuchilla El Rebote de laTarea DE Cuidado Mantenimiento Cronograma DE MantenimientoIADVERTENClA Para evitar Recomendaciones GeneralesLimpie EL Filtro DEL Aire Verifique QUE no Haya Piezas Daiiadas O GastadasInspeccione Y Limpie EL Apara To Y SUS Placas FijaMantenga a Cambio DE LA CuchillaAjuste AL Carburador Marcha LentaMotor Estacional AlmacenajeSistema DE Combustible OtrosTabla Diagnostica Rantia DE Responsabilidad DE DEL Dueiio Como dueiho de una SUS Derechos Y ObligacionesBierta DE Garantia DEL Fabri Fecha DEL Comienza DE LA GARECLAMACIONSicuentaustedcon manual del usuario

358.7958 specifications

The Craftsman 358.7958 is a robust and reliable gas-powered leaf blower that showcases the brand's commitment to quality and performance. Designed for both residential and commercial users, this blower is equipped with a powerful 25cc engine that delivers exceptional airspeed and airflow, making yard clean-up a breeze.

One of the standout features of the Craftsman 358.7958 is its impressive air speed capability. With air speeds of up to 230 mph, this leaf blower can easily tackle even the toughest leaves and debris. Whether you’re clearing fallen leaves in the fall or tidying up grass clippings after mowing, this model ensures efficient and effective performance.

The blower's lightweight design, weighing in at just over 9 pounds, makes it easy to maneuver and reduces operator fatigue during extended use. Additionally, the ergonomically designed handle features a comfortable grip, providing better control and enhancing user experience. The blower is also equipped with an adjustable throttle, allowing operators to easily control the speed and airflow based on the task at hand.

Another notable technology is the Craftsman Easy Start system. This feature reduces the effort needed to pull the starter cord, ensuring that users can fire up the engine with minimal hassle. This is particularly beneficial for those who may struggle with traditional starting mechanisms, making the leaf blower accessible to a wider range of users.

In terms of maintenance, the Craftsman 358.7958 is designed for easy access to key components. It comes with a simple fuel tank design for quick refueling and a tool-less air filter that makes maintenance straightforward and hassle-free. Users can enjoy peace of mind knowing that they can keep the equipment running smoothly with minimal effort.

Moreover, this gas-powered leaf blower operates with a two-stroke engine, offering a good balance between power and efficiency. Craftsman has ensured that this model meets emission standards, helping to reduce its environmental impact.

In conclusion, the Craftsman 358.7958 is an excellent choice for anyone looking for a powerful, user-friendly leaf blower. With its combination of impressive performance, ergonomic design, and easy maintenance, it stands out in the market and continues to be a favorite among homeowners and professionals alike.
Top Page Image Contents