Black & Decker 90548247 Assembly Instructions, Attaching Extension Cord to Trimmer

90548247 TR016 etc htrimmers 2/19/09 9:22 AM Page 6

ASSEMBLY INSTRUCTIONS

ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED):

- Phillips Screwdriver

ATTACHING BAIL HANDLE TO TRIMMER (HT012, HT018, HT020, HT022, HT512 ONLY) The trimmer is shipped with the bail handle tied to the trimmer. To attach the bail handle:

•Cut the zip tie which holds the handle to the trimmer.

•Remove the phillips head screws from both sides of the trimmer housing or from the carton.

•For catalog numbers (HT012, HT018, HT020, HT512), position the handle in place by sliding it on over the blade as shown in figure 1. Push the handle up onto the housing and click it into place as shown in figure 2.

•Insert the phillips head screws into the openings on both sides of the handle and tighten securely (do not over tighten) as shown in figure 3.

•For catalog number (HT022) attach the handle and insert the threaded screw through the handle and housing as shown in figure 4.

•Insert the two screws into the holes shown in figure 5 and screw down. Do not over tighten.

•Screw on the plastic knob to tighten handle to unit (figure 6).

NOTE: The handle on the HT022 is adjustable to three different positions as shown figure 7. To move handle, unscrew plastic knob, position handle as desired and retighten knob.

WARNING: DO NOT OPERATE THE HEDGE TRIMMER WITHOUT THE BAILHANDLE ATTACHED.

ATTACHING EXTENSION CORD TO TRIMMER

WARNING: BE SURE HEDGE TRIMMER IS NOT LOCKED ON.

An extension cord retainer is built into the switch handle that prevents the tool from coming unplugged. To use this feature, simply double the extension cord about 8 inches (203 mm) from the end, and insert it into the slot in the bottom of the handle area. Hook the loop formed by doubling the cord over the tab, as shown in figure 8. Gently tug on the cord to insure that it is firmly retained in the trimmer’s handle. Plug the receptacle end of the extension cord into the plug blades in the trimmer (figure 8).

SAVE THESE INSTRUCTIONS FOR FUTURE USE OPERATING INSTRUCTIONS

TO TURN THE TOOL ON

Pull the LOCK BUTTON back with your thumb and then squeeze the TRIGGER with your fingers as shown in figure 9. (Once the tool is running you can release the LOCK BUTTON.) To turn the tool OFF, release the TRIGGER.

TO LOCK THE TOOL ON FOR CONTINUOUS RUN

WITH THE TOOL RUNNING, pull the LOCK BUTTON ALL THE WAY back, release the TRIGGER, then release the LOCK BUTTON. The tool is now locked ON. To turn the tool OFF, squeeze and release the TRIGGER. NOTE: In order to lock the tool on, it is important to first release the trigger and then release the lock button.

TRIMMING INSTRUCTIONS

1.EXTENSION CORD – (Figures 8 and 10) Always keep extension cord behind trimmer and away from the trimming operation. Never drape it over a hedge being trimmed. If you cut or damage the cord, unplug it at the electrical outlet immediately, before inspecting or repairing cord.

2.WORKING POSITION – ( Figure 10) Maintain proper footing and balance and do not overreach. Wear safety goggles, non-skid footwear and rubber gloves when trimming. Hold the tool firmly in both hands and turn the tool ON. Always hold the trimmer, with one hand on the switch handle and one hand on the bail handle. Never hold the tool by the blade guard.

3.TRIMMING NEW GROWTH - (Figure 11) – A wide, sweeping motion, feeding the blade teeth through the twigs is most effective. A slight downward tilt of the blade, in the direction of motion gives the best cutting.

6