Snapper FLT19540RD, ELT2240RD Air Filter & Pre-Cleaner Service, Air Filter Removal & Installation

Air Filter & Pre-Cleaner Service

V-TWIN MODELS

Service Interval: Pre-Cleaner: Every 25 hours or as

required. Air Filter: Every 50 hours or as required.

Replacement Interval: Pre-Cleaner: As required. Air

Filter: Every 200 hours or once per season.

Air Filter Removal & Installation

1.Unscrew the four knobs (A, Figure 30) by turning counterclockwise.

2.Remove the cover (B). Remove the air filter (C) and pre-cleaner (D).

3.Install the pre-cleaner (D) with the mesh side up. Install the air filter (C) as shown.

4.Install the cover (B) making sure the tabs are inserted into their slots. Secure by turning screws clockwise until snug.

Pre-Cleaner Service

NOTE: Replace a worn or damaged pre-cleaner.

1.Wash the pre-cleaner in liquid detergent and water (see Figure 31).

2.Squeeze the pre-cleaner dry and saturate with engine oil. Remove all excess oil by squeezing the pre-cleaner in an absorbent cloth.

Air Filter Service

NOTE: Replace a worn or damaged air filter.

1.If stamped “Washable,” the filter can be washed with warm water and mild soap (see Figure 31).

2.Rinse with tap water with the screen side UP allowing dirt and debris to filter out.

3.Allow the filter to dry overnight before reinstalling

Regular Maintenance

Figure 30. Air Filter Assembly - V-Twin Models

A.Knobs

B.Cover

C.Air Filter

D.Pre-Cleaner

Figure 31. Air Filter Service