Snapper EM250819BE, EM281019BE Problem Probable Cause Corrective Action, Stop

Page 29

TROUBLESHOOTING

PROBLEM

 

PROBABLE CAUSE

 

CORRECTIVE ACTION

 

 

 

 

Engine Will Not

1. Fuel tank empty.

1.

Fill fuel tank with fresh fuel to proper level.

Start Using

2. Engine needs choking.

2.

Move choke control to “CHOKE” position.

Recoil Starter

3. Spark plug wire disconnected.

3.

Place spark plug wire onto spark plug.

 

4.

Faulty parking brake, blade or ignition switch.

4.

Contact authorized SNAPPER dealer.

 

5.

Park brake not engaged.

5.

Engage park brake.

 

6.

Ignition is in the OFF position.

6.

Turn ignition switch to the ON position.

Engine Will Not

1. Fuel tank empty.

1.

Fill fuel tank with fresh fuel to proper level.

Start Using

2. Engine needs choking.

2.

Move choke control to “CHOKE” position.

Electric Starter

3. Spark plug wire disconnected.

3.

Place spark plug wire onto spark plug.

 

4.

Faulty parking brake, blade or ignition switch.

4.

Contact authorized SNAPPER dealer.

 

5.

Park brake not engaged.

5.

Engage park brake.

 

6.

Blown Fuse.

6.

Replace with new 20 AMP fuse.

 

7.

Faulty interlock module.

7.

Contact authorized SNAPPER dealer.

 

8.

Ignition is in the OFF position.

8.

Turn ignition switch to the START position.

 

9.Battery is weak or dead.

9. Charge or replace with new battery.

 

10. Battery cables loose, broken disconnected or

10. Clean and connect battery cables. If

 

 

corroded.

 

broken, replace with new battery cables.

 

11. Faulty electric starter or starter solenoid.

11. Contact authorized SNAPPER dealer.

 

12. Starter cable loose, broken or disconnected

12. Connect starter cable. If broken, replace

 

 

 

 

with new starter cable.

 

13. Electrical wiring harness disconnected or broken.

13. Connect or replace with new wiring harness.

Engine Stalls After

1. Operator not in seat.

1.

Sit in operator’s seat.

Running

2. Choke control in the “CHOKE” position.

2. Move choke control to “OFF” position.

 

3.

Fuel tank empty.

3.

Fill fuel tank with fresh fuel to proper level.

 

4.

Engine air pre-cleaner and or air cleaner dirty.

4.

Clean free of all debris.

 

5.

Spark plug defective or gap set improperly.

5.

Service spark plug.

 

6.

Fuel filter restricted.

6.

Replace fuel filter.

 

7.

Water, debris or stale fuel in fuel system.

7.

Drain and clean fuel system.

 

8.

Vent on fuel cap closed.

8.

Open vent.

Engine Loses

1. Excessive load on engine.

1.

Lessen load.

Power

2. Engine air pre-cleaner or air cleaner dirty

2.

Clean or replace filters.

 

3.

Spark plug faulty.

3.

Service spark plug.

 

4.

Water, debris or stale fuel in fuel system.

4.

Drain and clean fuel system. Replace filter.

 

5.

Debris build up on engine cooling screen.

5. Clean all debris from engine cooling screen.

Engine Backfires

1. Throttle control set too “FAST”.

1. Set throttle control to “SLOW” and allow

When Turned To

 

 

 

engine to idle. Then, turn key to “OFF”.

“STOP”

 

 

 

 

Excessive Vibration

1. Damaged, out of balance or bent mower blades.

1.

Service mower blade(s).

 

2.

Loose blade components.

2.

Service and tighten loose parts.

 

3.

Loose or missing air lift (if equipped).

3.

Replace air lifts. Tighten to proper torque.

 

4.

Lumpy or frayed belt

4.

Replace belt.

 

5.

Bent Idler, stationary or spindle pulley

5.

Replace pulley.

(Trouble Shooting Continued on Next Page)

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Manual No -3121 I.R /20/99 European Rear Engine Riding Mower SeriesImportant Safety Instructions Operation Table of Contents Nomenclature IntroductionFamiliarization Decals / Symbols Lowest Traction Height CUT Clutch PRE-START Check List OPERATOR’S Seat Adjustment 2.2.1. Front to Rear AdjustmentOn Next Starting & Operation Engine Electric StartEngine Manual Start Starting & OperationEngine Electric Start Wheel Drive Starting & Operation 2.3.3. Mower BladeMower Blade Stopping ENGINE, Wheel DRIVE, Blade 2.4.1. EngineDo not park machine on slopes Cutting Height AdjustmentStopping ENGINE, Wheel DRIVE, Blade 2.4.4. Park Brake Service Engine AIR Cleaner Check Mower Blade Service After First 5 Hours Change Engine OILBlade Brake Service After First 5 Hours 3.2.4. Check Blade Drive BeltService Brake / Park Brake Clean Mower Deck Service Every 25 Operating HoursBattery Fluid Level Interlock SystemRear Axle Bearing Lubrication Service Every 25 Operating Hours from previousFront Wheel Bearing Lubrication Engine Service AnnuallyFuel Filter Every TWO YearsRemoving Fuel Tank Storage OUT of SeasonMower Drive Belt Adjustment for 25, 28 & 30 M Models Engine Adjustments & RepairMower Deck Adjustment Side-To-Side Levelness Blade Brake AdjustmentFront to Rear Levelness 30 Decks Mower Deck AdjustmentFront to Rear Levelness 25 & 28 Decks Chain Case Clutch Yoke Cable Housing Spring Blade Sharpening Mower Blade Replacement 4.4.1. Blade Wear LimitsBelt Removal Blade Drive Belt ReplacementBelt Replacement Battery Installation Battery Battery RemovalBattery Storage Battery ServiceNEW Battery Preparation 1. Remove battery from carton Battery TestingSnapper Rear Engine Rider Accessories Stop Problem Probable Cause Corrective ActionBlades Not Cutting Loss Of TractionCutting Grass ImproperlyTo be Performed Pages Subject Service ReferenceMAINTENANCE/REPLACEMENT Parts Maintenance Parts Disclaimer of Warranty Year Limited WarrantyService Notes Service Notes European Rear Engine Riding Mower Series

EM250819BE, EM281019BE specifications

The Snapper EM250819BE and EM281019BE are two advanced electric mowers that embody the latest innovations in outdoor power equipment. Aimed at both residential and commercial users, these models offer exceptional performance, efficiency, and user-friendly features to simplify lawn care.

The Snapper EM250819BE features a robust 20-inch cutting deck, providing the ideal balance between maneuverability and coverage. This mower is powered by a high-efficiency brushless motor, which not only extends the lifespan of the instrument but also delivers consistent power output, ensuring an even cut across various grass types. The EM250819BE offers multiple cutting height adjustments, allowing users to customize their lawn's appearance according to seasonal preferences and grass species.

Equipped with a 40V lithium-ion battery, the Snapper EM250819BE boasts an impressive runtime, enabling users to tackle larger yards without interruptions for recharging. The onboard LED battery indicator is particularly handy, allowing users to monitor battery levels easily and plan their mowing schedule without surprises. Additionally, the mower's lightweight design ensures easy maneuverability, making it less strenuous to operate for extended periods.

On the other hand, the Snapper EM281019BE brings a larger 28-inch cutting deck into play, perfect for those who need to cover wider areas quickly. Like its counterpart, this model features a brushless motor that ensures efficient operation and reduces maintenance needs. The EM281019BE also supports various cutting height settings for a tailored mowing experience.

One of the standout features of the EM281019BE is its self-propelled option, allowing users to navigate tougher terrains with minimal effort. This is complemented by enhanced traction control, making it ideal for slopes and uneven lawns. The model also includes a proprietary mulching feature, enabling grass clippings to be finely chopped and returned to the soil, thus promoting healthier lawn growth.

Both models are designed with user comfort and safety in mind. They come with ergonomic handles for better grip and reduced fatigue during extended use. Additionally, the easy-to-access safety features ensure that the mowers meet the highest standards of user protection.

In summary, the Snapper EM250819BE and EM281019BE represent a significant advancement in electric mowing technology, delivering performance, efficiency, and convenience in an environmentally friendly package. With their user-centric design and powerful features, they are excellent choices for anyone looking to achieve a beautiful lawn with less hassle.
Top Page Image Contents