Torque Mower Blade Hardware, Axion / 150Z Series

Contents Initial setup Axion / 150Z SeriesTABLE OF CONTENTS Axion / 150Z SeriesSETUP PROCEDURES GENERAL OPERATION TRANSPORTING AND STORAGESAFETY RULES SLOPE OPERATION CHILDRENEMISSIONS TOWED EQUIPMENT RIDE-ON UNITSSERVICE AND MAINTENANCE Service & MaintenanceSafe Handling of Gasoline Quick Setup List Charge the battery Note proceed with other setup stepswhile battery is charging Front tires 18-20 psi, rear tires 10-12 psiUncrating IMPORTANT NOTEDO NOT TOW RIDER Figure 1. Pushing the riderBattery Activation Installation Charge BatteryInstall Battery Figure 2. Charging the batteryInstalling the Seat 5/16-18 x 3/4Figure 5. Installing the seat 19-25 N.m 14-19 ft. lbsInstalling the Seat Safety Switch Figure 6. Installing the seat safety switchBB D Setting Up the Ground Speed Control Levers 5/16-18 5/16-18 x 1-3/4Figure 7. Setting up the ground speed levers 20-23 N.m 15-17 ft. lbsTorque Mower Blade Hardware Note Use a wooden block to prevent blade rotationA B 41-54 N.m 30-40 ft. lbs Figure 8. Torquing the mower blade hardware 33” DeckA B 108-122 N.m 80-90 ft. lbs Figure 9. Torquing the mower blade hardware 42” Deck A B 61-75 N.m45-55 ft. lbs Figure 10. Torquing the mower blade hardware 50” Deck Check Fluid Levels Reduce & Check Tire PressuresFill & Check Engine Oil SizeLubrication Grease42” Deck shown, all decks similar Figure 13. Lubrication deck Figure 14. Lubrication ground speed control leversCHECK RIDER SAFETY SYSTEM Operational SAFETY ChecksBurnish PTO Clutch