Snapper 7800391, 7800388, 7800390 Quick Setup List, Axion / 150Z Series, while battery is charging

Contents Initial setup Axion / 150Z SeriesTABLE OF CONTENTS Axion / 150Z SeriesSETUP PROCEDURES GENERAL OPERATION TRANSPORTING AND STORAGESAFETY RULES EMISSIONS SLOPE OPERATIONCHILDREN TOWED EQUIPMENT RIDE-ON UNITSSERVICE AND MAINTENANCE Service & MaintenanceSafe Handling of Gasoline while battery is charging Quick Setup ListCharge the battery Note proceed with other setup steps Front tires 18-20 psi, rear tires 10-12 psiDO NOT TOW RIDER UncratingIMPORTANT NOTE Figure 1. Pushing the riderInstall Battery Battery Activation InstallationCharge Battery Figure 2. Charging the batteryFigure 5. Installing the seat Installing the Seat5/16-18 x 3/4 19-25 N.m 14-19 ft. lbsInstalling the Seat Safety Switch Figure 6. Installing the seat safety switchBB D Figure 7. Setting up the ground speed levers Setting Up the Ground Speed Control Levers5/16-18 5/16-18 x 1-3/4 20-23 N.m 15-17 ft. lbsA B 41-54 N.m 30-40 ft. lbs Torque Mower Blade HardwareNote Use a wooden block to prevent blade rotation Figure 8. Torquing the mower blade hardware 33” DeckA B 108-122 N.m 80-90 ft. lbs Figure 9. Torquing the mower blade hardware 42” Deck A B 61-75 N.m45-55 ft. lbs Figure 10. Torquing the mower blade hardware 50” Deck Fill & Check Engine Oil Check Fluid LevelsReduce & Check Tire Pressures Size42” Deck shown, all decks similar Figure 13. Lubrication deck LubricationGrease Figure 14. Lubrication ground speed control leversCHECK RIDER SAFETY SYSTEM Operational SAFETY ChecksBurnish PTO Clutch