Snapper 7800390, 7800388, 7800391 Uncrating, Axion / 150Z Series, Important Note, Do Not Tow Rider

Page 7

Uncrating

Axion / 150Z Series

Uncrating

1.Using a reciprocating utility saw or equivalent, cut crate away from bottom skid. Remove crate. Remove plastic wrap.

2.Cut any banding securing the unit.

IMPORTANT NOTE

When cutting crate from bottom skid, use caution around tires and mower rollers.

3.Locate the transmission release levers (C, Figure 1) at the rear of the unit.

4.Pull both levers back and down to release the trans- missions (position B, Figure 1).

5.Pull the ground speed control levers in to their DRIVE positions, and disengage the parking brake.

The rider can now be pushed by hand.

6.After moving the rider, set the ground speed control levers to START/PARK, engage the parking brake, and push both transmission release levers forward to re-engage the transmissions (position A, Figure 1).

DO NOT TOW RIDER

Towing the unit will cause transmission dam- age. Do not use another vehicle to push or pull this unit. Do not use this unit to push or pull another vehicle or object.

A

B

C

Figure 1. Pushing the rider

8/2008

7

TP 300-5412---ZT-SN

Image 7

Contents Axion / 150Z Series Initial setupAxion / 150Z Series TABLE OF CONTENTSSETUP PROCEDURES TRANSPORTING AND STORAGE GENERAL OPERATIONSAFETY RULES TOWED EQUIPMENT RIDE-ON UNITS SLOPE OPERATIONCHILDREN EMISSIONSService & Maintenance SERVICE AND MAINTENANCESafe Handling of Gasoline Front tires 18-20 psi, rear tires 10-12 psi Quick Setup ListCharge the battery Note proceed with other setup steps while battery is chargingFigure 1. Pushing the rider UncratingIMPORTANT NOTE DO NOT TOW RIDERFigure 2. Charging the battery Battery Activation InstallationCharge Battery Install Battery19-25 N.m 14-19 ft. lbs Installing the Seat5/16-18 x 3/4 Figure 5. Installing the seatFigure 6. Installing the seat safety switch Installing the Seat Safety SwitchBB D 20-23 N.m 15-17 ft. lbs Setting Up the Ground Speed Control Levers5/16-18 5/16-18 x 1-3/4 Figure 7. Setting up the ground speed leversFigure 8. Torquing the mower blade hardware 33” Deck Torque Mower Blade HardwareNote Use a wooden block to prevent blade rotation A B 41-54 N.m 30-40 ft. lbsFigure 9. Torquing the mower blade hardware 42” Deck A B 61-75 N.m A B 108-122 N.m 80-90 ft. lbs45-55 ft. lbs Figure 10. Torquing the mower blade hardware 50” Deck Size Check Fluid LevelsReduce & Check Tire Pressures Fill & Check Engine OilFigure 14. Lubrication ground speed control levers LubricationGrease 42” Deck shown, all decks similar Figure 13. Lubrication deckOperational SAFETY Checks CHECK RIDER SAFETY SYSTEMBurnish PTO Clutch