Snapper 1725580, 1694389 Install Hitch, Install Back Plate Hair Pin Clip Hitch Pin Lower Spacer

Page 5

Initial Hitch Installation - Models with out 3-Point Hitch

C
E		B
		B
	G	D
		D
	A
	A	F
		F

Figure 1. Install Side Brackets

A. Side Brackets	E.	Lockwashers, 1/2
B. Spacers	F.	Clevis Pins
C. Nuts, 1/2-13	G.	Safety Clips

D. Capscrews, 1/2-13 x 2-1/2

INITIAL HITCH INSTALLATION - MODELS WITHOUT 3-POINT HITCH

Install Hitch

1.Mount two side brackets (A, Figure 1) to the same side of the frame placing spacers (B) between side brackets (A). Secure with two 1/2-13 x 2-1/2 cap- screws (D) 1/2 lock washers (E) and 1/2-13 nuts (C) per side.

2.Install the hitch assembly (A, Figure 2). Secure with 1/2-13 x 1-1/4 capscrews (D), 1/2 washers (B) and 1/2-13 nuts (C)

3.Install the back plate (B, Figure 3) on the lower spac- ers (D) and secure to the hitch with the long hitch pin

(C) and hair pin clip (A).

C	B
	B
A
	D

Figure 2. Install Hitch Assembly

A.Hitch Assembly

B.Lockwashers, 1/2

C.Nuts, 1/2-13

D.Capscrews, 1/2-13 x 1-1/4

B

A

C

D

Figure 3. Install Back Plate

A.Hair Pin Clip

B.Back Plate

C.Hitch Pin

D.Lower Spacer

4

Image 5

Contents OPERATOR’S Manual Clean Sweep Triple CatcherTable of Contents Decal Warning Do Not Open Cover Part Number Safety DecalsAttachment Decals Before Operation Required AccessoriesMowing with the Catcher After OperationInstall Back Plate Hair Pin Clip Hitch Pin Lower Spacer Install HitchHole Lift arm mustAssemble Front and Back Plate Initial Installation & AssemblyHoles for 54 Mowers Holes for 48 & 60 Mowers Assemble Tubes & DeflectorSee Figure Install CoverAssemble Catcher Bags Remove the Cover Hinge Hinge Pin Hair Pin Clip Removing the Grass CatcherModels with 3-Point Hitch Reattaching Grass CatcherModels with out 3-Point Hitch Bags Back Plate Hardware Identification & Torque Specifications