Snapper 1694389, 1725580 manual Lift arm must, Hole

Initial Hitch Installation Models with 3-Point

		A
		B	C
D		C
	E	D
		E

Figure 4. Install Side Brackets

A.Tube Assembly & Mounting Hardware

B.Clevis Assembly & Mounting Hardware

C.Lower Link & Chain Assembly

D.Hair Pin

E.Clevis Pin

INITIAL HITCH INSTALLATION - MODELS WITH 3 POINT HITCH

Install Hitch

1.Remove the tube assembly & mounting hardware (A, Figure 4).

2.Remove the two clevis assemblies & mounting hard- ware (B, Figure 4).

3.Remove the two lower link & chain assemblies (C, Figure 4) by removing hair pins (D) and clevis pins

(E). Reinsert clevis pins (E) and hair pins (D)

4.Raise the lift arm (E, Figure 5) up above the lower hole of the 3-point hitch (F). Install the back plate (B, Figure 5) on the clevis pins (D) and secure to the hitch with the long hitch pin (C) and hair pin clip (A).

A

B

C

E

Lift arm must

be above lower

hole.

F

D

Figure 5. Install Side Brackets

A.Hair Pin Clip

B.Back Plate

C.Hitch Pin

D.Clevis Pin

E.Lift Arm

F.3-Point Hitch

5