Snapper 1694389, 1725580 Assemble Tubes & Deflector, Holes for 54 Mowers Holes for 48 & 60 Mowers

Initial Installation & Assembly

		D		C
				J
					E
					I
				K	J	F
		A	B				H
							K
L	M				J		J
A. Deflector	H. Nut			H
B. Back Plate	I.	Capscrew,			G
C. Capscrew,		1/4-20 x 1-1/4
5/16-18 x 1	J. Washer, 1/4				K		G
D. Socket	K. Hook
E. Upper Tube	L. Locknut, 5/16-18				H	J	J
F. Lower Tube	M. Washer, 5/16
G. Rubber Strap							I

Figure 8. Assemble Tubes & Deflector

A

C

B

Figure 9. Mount Deflector and Tube Pivot

A. Tube Pivot C. 5/16” Mounting Hardware B. Deflector

Assemble Tubes & Deflector

1.All models covered by this manual require the upper tube (E, Figure 8) to be left at full length.

2.If not already done, insert the upper tube (E, Figure 8) into the socket (D). Insert the tube from the front. This will require some effort.

3.Mount the socket (D, Figure 8) and deflector (A) to

Holes for 54” Mowers

Holes for 48” & 60” Mowers

Figure 10. “S” Hook Hole Locations

the back plate (B) using the four 5/16-18 x 1” cap- screws (C), eight flat washers (M), and four nylock nuts (L) as shown in Figures 8 & 9.

4.Insert the lower tube (F) into the upper tube (E). Secure the elbow to the turbo using “S” hooks (K) and a rubber strap (G). Assemble as shown in Figure 8. Use Figure 10 to determine correct hole locations for hooks (K).

Note: Use correct hole locations to maintain proper tube connections and prevent lower tube from disconnecting from the turbo.

7