Snapper Z-Mow / 150Z manual Safety Rules, General Operation

Page 4

SAFETY RULES

Read these safety rules and follow them closely. Failure to obey these rules could result in loss of control of unit, severe personal injury or death to you, or bystanders, or damage to property or equipment.

This mowing deck is capable of amputating hands and feet and throwing objects.

The triangle in text signifies important cautions or warnings which must be followed.

GENERAL OPERATION

1.Read, understand, and follow all instructions in the manual and on the unit before starting.

2.Do not put hands or feet near rotating parts or under the machine. Keep clear of the discharge opening at all times.

3.Only allow responsible adults, who are familiar with the instructions, to operate the unit (local regulations can restrict operator age).

4.Clear the area of objects such as rocks, toys, wire, etc., which could be picked up and thrown by the blade(s).

5.Be sure the area is clear of other people before mow- ing. Stop the unit if anyone enters the area.

6.Never carry passengers.

7.Do not mow in reverse unless absolutely necessary. Always look down and behind before and while travel- ling in reverse.

8.Never direct discharge material toward anyone. Avoid discharging material against a wall or obstruction. Material may ricochet back toward the operator. Stop the blade(s) when crossing gravel surfaces.

9.Do not operate the machine without the entire grass catcher, discharge guard (deflector), or other safety devices in place and operational.

10.Slow down before turning.

11.Never leave a running unit unattended. Always disen- gage the blades (PTO), set parking brake, stop engine, and remove keys before dismounting.

12.Disengage blades (PTO) when not mowing. Shut off engine and wait for all parts to come to a complete stop before cleaning the machine, removing the grass catcher, or unclogging the discharge guard.

13.Operate the machine only in daylight or good artificial light.

14.Do not operate the unit while under the influence of alcohol or drugs.

15Watch for traffic when operating near or crossing roadways.

16.Use extra care when loading or unloading the unit into a trailer or truck.

17.Always wear eye protection when operating this unit.

18.Data indicates that operators, age 60 years and above, are involved in a large percentage of power equipment-related injuries. These operators should evaluate their ability to operate the equipment safely enough to protect themselves and others from injury.

19.Follow the manufacturer’s recommendations for wheel weights or counterweights.

20.Keep in mind the operator is responsible for accidents occurring to other people or property.

21.All drivers should seek and obtain professional and practical instruction.

22.Always wear substantial footwear and trousers. Never operate when barefoot or wearing sandals.

23.Before using, always visually check that the blades and blade hardware are present, intact, and secure. Replace worn or damaged parts.

24.Disengage attachments before: refueling, removing an attachment, making adjustments (unless the adjustment can be made from the operator’s posi- tion).

25.When the machine is parked, stored, or left unattend- ed, lower the cutting means unless a positive mechanical lock is used.

26.Before leaving the operator’s position for any reason, engage the parking brake (if equipped), disengage the blades (PTO), stop the engine, and remove the key.

27.To reduce fire hazard, keep the unit free of grass, leaves, & excess oil. Do not stop or park over dry leaves, grass, or combustible materials.

28.It is a violation of California Public Resource Code Section 4442 to use or operate the engine on or near any forest-covered, brush-covered, or grass-covered land unless the exhaust system is equipped with a spark arrester meeting any applicable local or state laws. Other states or federal areas may have similar laws.

29.OSHA regulations may require the use of hearing protection when exposed to sound levels greater than 85 dBA for an 8 hour time period.

CAUTION

This machine produces sound levels in excess of 85 dBA at the operator’s ear and can cause hearing loss though extended

periods of exposure.

Wear hearing protection when operating this machine.

TRANSPORTING AND STORAGE

1.When transporting the unit on an open trailer, make sure it is facing forward, in the direction of travel. If the unit is facing backwards, wind lift could damage the unit.

2.Always observe safe refueling and fuel handling prac- tices when refueling the unit after transportation or storage.

3.Never store the unit (with fuel) in an enclosed poorly ventilated structure. Fuel vapors can travel to an igni- tion source (such as a furnace, water heater, etc.) and cause an explosion. Fuel vapor is also toxic to humans and animals.

4.Always follow the engine manual instructions for storage preparations before storing the unit for both short and long term periods.

5.Always follow the engine manual instructions for proper start-up procedures when returning the unit to service.

6.Never store the unit or fuel container inside where there is an open flame or pilot light, such as in a water heater. Allow unit to cool before storing.

TP 600-4103-01-ZT-UV

2

Image 4
Contents OPERATOR’S Manual Mfg. No DescriptionPage Table of Contents Safety Rules General OperationIgnition System Service & Maintenance Safe Handling of GasolineSafety & Operation Decals Identification Numbers North AmericanCE Models OnlyPRE-OPERATION Read The Operator’s ManualOperation Control FunctionsGround Speed Levers Parking Brake Throttle ControlGeneral Operating Safety Checks Before Starting Fuel RecommendationsEmergency Stopping Stopping the Rider & EngineStarting the Engine MowingDriving Practice Smooth TravelForward Travel Practice Reverse Travel PracticePractice Turning Around a Corner Practice Turning In PlaceExecuting Turns Executing an End-Of-Row Zero TurnInstalling the Mower Deck Mower Deck Removal InstallationRemoving the Mower Deck Maintenance Maintenance ScheduleRider MAINTENANCE, All Models 18.5HP Briggs & StrattonClean Debris from Engine Cooling Areas and AIR Filter Clean Debris from Rider and Engine CompartmentCheck Tire Pressure Grease LubricationOil Clean Deck Check / Replace Mower Blades Blade RemovalCheck Rider Safety System Cleaning the Battery and CablesOperational Safety Checks Check / Adjust PTO Clutch Adjust PTO Clutch Window Adjustment Nut Feeler GaugeChange Engine OIL Check Engine OIL LevelChange Engine OIL & Filter AIR Filter & PRE-CLEANER Air Filter Removal & InstallationAir Filter Service Pre-Cleaner Pre-Cleaner ServiceReplace Spark Plug Ground Speed Control Lever Adjustment Service & AdjustmentsSpeed Balancing Adjustment Cutting Height Adjustment PTO Clutch AdjustmentBrake Adjustment Battery ChargingMower Deck Leveling Adjustments Side to Side LevelingMower Drive Belt Replacement Mower Belt ReplacementFront To Back Leveling Storage StorageTroubleshooting Troubleshooting the RiderTroubleshooting the Mower Dimensions EngineChassis TransmissionPage Page RO D U C T S