Snapper YZ18425BVE, YZ20485BVE Protection for Children, Protection Against Tipovers, Preparation

Page 2

IMPORTANT SAFETY INSTRUCTIONS

WARNING: This powerful cutting machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following SAFETY instructions could result in serious injury or death to the operator or other persons. The owner of the machine must understand these instructions and must allow only persons who understand these instructions to operate machine. Each person operating the machine must be of sound mind and body and must not be under the influence of any substance, which might impair vision, dexterity or judgment. If you have any questions pertaining to your machine which your dealer cannot answer to your satisfaction, call or write the Customer Service Department at SNAPPER, McDonough, Georgia 30253. Phone: (1-800-935-2967).

PROTECTION FOR CHILDREN

Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine and the mowing activity. Never assume that children will remain where you last saw them.

1.KEEP children out of the mowing area and under the watchful care of a responsible adult.

2.DO NOT allow children in yard when machine is operated (even with the blade OFF).

3.DO NOT allow children or others to ride on machine, attachments or towed equipment (even with the blades OFF). They may fall and be seriously injured.

4.DO NOT allow pre-teenage children to operate machine.

5.ALLOW only responsible adults & teenagers with mature judgment under close adult supervision to operate machine.

6.DO NOT operate blades in reverse. STOP BLADES. LOOK and SEE behind and down for children, pets and hazards before and while backing.

7.USE EXTRA CARE when approaching blind corners, shrubs, trees, or other objects that may obscure vision.

PROTECTION AGAINST TIPOVERS

(Continued From Previous Column)

6.KEEP A SAFE DISTANCE (at least 3 feet) away from edge of ditches and other drop offs. The machine could turn over if an edge caves in.

7.Always begin forward motion slowly and with caution.

8.Use weights or a weighted load carrier in accordance with instructions supplied with a grass catcher. DO NOT operate machine on slopes exceeding 10 degrees (18% grade) when equipped with grass catcher.

9.DO NOT put your foot on the ground to try to stabilize the machine.

10.DO NOT operate machine on wet grass. Reduced traction could cause sliding.

11.Chose a low enough speed setting so that you will not have to stop or shift on a slope. Tires may lose traction on slopes even though the brakes are functioning properly.

12.DO NOT operate machine under any condition where traction, steering or stability is doubtful.

13.Always keep the machine in gear when going down slopes. DO NOT shift to neutral (or actuate hydro roll release) and coast downhill.

PROTECTION AGAINST TIPOVERS

Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All slopes require extra CAUTION. If you cannot back up the slope or if you feel uneasy on the slope, DO NOT mow it. Use extra care with grass catchers or other attachments; these affect the handling and the stability of the machine.

1.DO NOT operate machine on slopes exceeding 15 degrees (27% grade).

2.Exercise EXTREME CAUTION on slopes above 10 degrees (18% grade). Turn blades OFF when traveling uphill. Use a slow speed and avoid sudden or sharp turns.

3.DO NOT operate machine back and forth across face of slopes. Operate up and down. Practice on slopes with blades off.

4.AVOID starting, stopping or turning on slopes. If machine stops going uphill or tires lose traction, turn blades OFF and back slowly straight down the slope.

5.STAY ALERT for holes and other hidden hazards. Tall grass can hide obstacles. Keep away from ditches, washouts, culverts, fences and protruding objects.

PREPARATION

1.Read, understand, and follow instructions and warnings in this manual and on the machine, engine and attachments. Know the controls and the proper use of the machine before starting.

2.Only mature, responsible persons shall operate the machine and only after proper instruction.

3.Data indicates that operators age 60 and above, are involved in a large percentage of mower-related injuries. These operators should evaluate their ability to operate the mower safely enough to protect themselves and others from serious injury.

4.Handle fuel with extra care. Fuels are flammable and vapors are explosive. Use only an approved fuel container. DO NOT remove fuel cap or add fuel with engine running. Add fuel outdoors only with engine stopped and cool. Clean spilled fuel from machine. DO NOT smoke.

5.Practice operation of machine with BLADES OFF to learn controls and develop skills.

6.Check the area to be mowed and remove all objects such as toys, wire, rocks, limbs and other objects that could cause injury if thrown by blade or interfere with mowing.

2

Image 2
Contents Scrambler Model Number ExplanationPreparation Protection for ChildrenProtection Against Tipovers Safe Handling of Gasoline OperationMaintenance Table of Contents Introduction NomenclatureOperating Instructions PRE-START Check ListStarting & Operation Engine Electric Start On NextWheel Drive Mower Blade StoppingEngine Mower BladeEngine should Start if Cutting Height AdjustmentEngine Must not Start if Engine Must Begin to Stop ifCheck Mower Blade Service After First 5 HoursChange Engine OIL Twin & Triple Blade DeckService Every 25 Operating Hours Check Transaxle Drive BeltService Every 25 Operating Hours 3.3.1. Engine Mower ComponentsFront Wheel Bearings Mower Deck Linkage LubricationScrambler Lubrication Service Annually Storage OUT of SeasonBelt Replacement Engine Adjustments & RepairMower Drive Belt Adjustment Belt RemovalRefer to Section MAINTENANCE/REPLACEMENT Parts Blade BrakeHairpin Lift ARM Single Blade Deck Front or Rear View of DeckTwin Blade Deck Deck ShownWheel Brake Adjustment Numbers refer to Section Maintenance /REPLACEMENT Parts Mower Blade Replacement 4.3.1. Blade Wear LimitsBlade Replacement Blade SharpeningBattery Service Battery Battery RemovalBattery Installation 1. Slide battery into battery cradle Battery StorageBattery Condition Chart Battery TestingCorrective Action Problem Probable CauseTrouble Shooting on Next MAINTENANCE/REPLACEMENT Parts Loss Of TractionUSE HRS Season Service Performed Each100 Year Limited Warranty Disclaimer of WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Snapper Product Registration Form Scrambler Hydro Drive Series

YZ18425BVE, YZ20485BVE specifications

The Snapper YZ18425BVE and YZ20485BVE represent a significant advancement in outdoor power equipment, specifically designed for those who seek performance, reliability, and efficiency in their lawn care endeavors. These models combine cutting-edge technology and user-friendly features, making them ideal choices for both residential and commercial applications.

At the heart of both models is a robust engine designed to deliver exceptional power. The YZ18425BVE features an 18 horsepower engine, while the YZ20485BVE boasts a more powerful 20 horsepower variant. This substantial power allows for swift and efficient mowing, easily cutting through thick grass and tackling uneven terrains. Both engines are engineered with fuel efficiency in mind, enabling longer operational hours on a single tank and reducing the frequency of refueling.

One of the standout features of the Snapper YZ series is its innovative cutting deck design. With a precise cutting width of 42 inches for the YZ18425BVE and 48 inches for the YZ20485BVE, these mowers provide a clean and consistent cut, ensuring an immaculate lawn. The deck is constructed for durability, featuring advanced materials that withstand the rigors of regular use while maintaining performance.

User comfort and control are paramount in the design of these models. Both mowers come equipped with an ergonomic seat and an intuitive control layout, allowing operators to maneuver with ease and precision. The YZ20485BVE also includes advanced suspension features that enhance the overall riding experience, reducing vibrations and increasing operator comfort during extended use.

In terms of safety, the Snapper YZ series prioritizes user protection. Key safety features include automatic blade shut-off systems and easy-to-reach controls that ensure operators can quickly respond to any situation. Additionally, these models are designed with stability in mind, featuring a wide wheelbase that improves traction and control on various terrains.

Both the YZ18425BVE and YZ20485BVE are equipped with easy maintenance features, such as accessible oil and air filters, allowing users to perform routine checks and servicing without hassle. This commitment to maintenance ease ensures that the mowers remain in peak condition for years of reliable service.

Overall, the Snapper YZ18425BVE and YZ20485BVE are exemplary choices for those looking for high-performance lawn mowers that combine power, efficiency, and user comfort.