La Crosse Technology WS-8035 Detailed SET-UP Guide, Battery Installation, Indoor Weather Station

Page 5

DETAILED SET-UP GUIDE

I.Battery Installation

Batteries will fit tightly. To avoid start-up problems, make sure that the batteries do not spring free. Also be sure to insert alkaline batteries into the remote thermo/hygro sensor first, then the indoor weather station. Initial set up should be done with the remote thermo/hygro sensor and indoor weather station in the same room. The units should be permanently mounted only after the signal reception has been verified.

	Mounting
	Bracket/Recept
	Battery
Rain	Cover
Cover

Thermo-Hygro

Sensor

A.Remote Temperature and Humidity Sensor

1.Pull the cylindrical rain cover off the sensor.

2.Remove the battery cover (located on the backside of the sensor, above the mounting post and bracket). Press the arrow and slide the battery cover off.

3.Observing the correct polarity install 2 Alkaline AA batteries.

4.Replace battery cover, and place rain cover snugly onto the sensor.

B.Indoor Weather Station

1.Remove the battery cover (the cover has white writing on it).

2.Observe the correct polarity, and install three Alkaline AA batteries.

3. Do not press any buttons for at least ten minutes. If a button is pressed before the indoor weather station has received information from the TX4U sensor, no data will be received from that sensor until reset.

4.Replace the battery cover.

5

Image 5

Contents WS-8035 Wireless 433 MHz Wireless Weather Station Table of Contents Inventory of Contents Do not Press ANY Buttons for 15 Minutes Quick SET-UP GuideRemote Temperature and Humidity Sensor Battery InstallationDetailed SET-UP Guide Indoor Weather StationWwvb Reception II. Start Up Sequence Initial StartIII. Explanation of LCD Information Overview of programming mode sequence Program ModeLCD Contrast Setting Time Zone Setting12/24-hour Time Mode DST ON/OFF SettingRadio-controlled Time ON/OFF Setting Setting The Minutes Manually Setting The Hour ManuallySetting The Year Manually Setting The Month ManuallyTemperature Measuring Units Selection F or C Setting The Date ManuallyRelative Pressure Setting Air Pressure Measuring Units Selection inHg/hPaManual Setting is NOW Completed Forecast Sensitivity SettingTime Alarm Setting and Operation Features and OperationsMoon Phase Set Up of Multiple Units Outdoor Minimum and Maximum Temperature and HumidityMultiple Remote Temperature Sensors Viewing and Operating with Multiple Remote Sensors Comfort Indicator for Indoor Temperature and HumidityWeather Forecast Icon and Pressure Trend Indicators Weather Tendency Arrows Weather IconsBarometric Air Pressure Reading Air Pressure History Bar ChartMounting the Remote Thermo/hygro Sensor VII. MountingMounting the WS-8035 Indoor Weather Station Maintenance and Care Instructions Solution TroubleshootingProblem Specifications Warranty Information Support@lacrossetechnology.com