La Crosse Technology TX4U Detailed SET-UP Guide Battery Installation, Remote THERMO-HYGRO Sensor

Page 4

Battery Compartment

DETAILED SET-UP GUIDE

I.BATTERY INSTALLATION

Batteries will fit tightly. To avoid start-up problems, make sure that the batteries do not spring free.

A.REMOTE THERMO-HYGRO SENSOR

Mounting

Bracket/Receptor

Rain Cover

Battery Cover

Thermo-Hygro

Sensor

1. Pull the cylindrical rain cover off the sensor.

2. Remove the battery cover (located on the backside of the sensor, above the mounting post and bracket). Press the arrow and slide the battery cover off.

3. Observing the correct polarity install 2 AA batteries.

4. Replace battery cover, and place rain cover snugly onto the sensor.

B. RAINFALL SENSOR

1. Remove the flat-head screw and battery cover, located on the underside of the base.

2. Observe the correct polarity, and install two

AA batteries.

3.Make sure the rubber weather seal is in place and replace the battery cover and screw.

4

Image 4

Contents Page Table of Contents Inventory of Contents Quick SET-UP GuideRemote THERMO-HYGRO Sensor Detailed SET-UP Guide Battery InstallationRainfall Sensor Weather Center LCD ScreensProgram Mode II. Setting the LCD ContrastFunction Buttons III /24 Hour Time Display SelectionTime Zone Setting IV. Time SettingVI. Date Setting IX. Weather Forecast Sensitivity Setting VII. Date Display SettingVIII. Selecting F or C and Inches or Millimeters Displaying Relative hPa/inHg or Absolute hPa/inHg XI. Manually Setting the Relative AIR Pressure XII. Selecting BAR Graph DisplayFeatures & Operations Moon Phase Waning Moon PhasesII. Minimum & Maximum Temperatures Displays and Functions III. Weather Forecast & Weather Icons Resetting the Minimum & Maximum RecordsWeather Icons Weather Tendency Arrows Comfort Level IndicatorStorm Warning IV. BAR Graph Histories AIR Pressure History Rainfall History Rainfall Quantity VI. Resetting Rainfall Information Rainfall Quantity Totals Manual Setting of the Rain MultiplicatorHard Reset of Eeprom Weather Center Memory VII. Adding More Sensors optionalSelecting Which Sensor Data to Display SET-UP of Multiple SensorsMounting Mounting with the Screws TX4U-REMOTE THERMO-HYGRO SensorMounting with Adhesive Tape II. the TX5U-RAINFALL Sensor III. the WS-7095U-WEATHER CenterHanging holes Maintenance and Care TroubleshootingProblem SolutionSpecifications Power supply Sensor reading updateDimensions L x W x H Warranty Information Support@lacrossetechnology.com