La Crosse Technology WS-2510 Programming mode entering alarm values, Alarm values can be set for

Page 22

3.4.Programming mode (entering alarm values)

You can program the weather station so that an audible-visible alarm occurs when certain minimum or maximum values are reached. As well as this, daily wake-up times can be programmed so that the weather station can also be used as an alarm clock or an appointment reminder.

Alarm values can be set for:

-High or low temperature for all sensors

-High or low humidity for all sensors with humidity

-High and low air pressure

-High wind speed

-Daily wake-up time

-Separate wake-up time for each day of the week

3.4.1.Programming the min/max alarm values

-The programming mode is selected by touching field 29 (“ALARM VALUES”).

The display shown below is an example of how the screen appears for the MAX alarm values and the daily wake-up time. If no alarm value has been set, dashes appear in place of the value display. Wake-up times are only shown in the MAX display.

-To access the display for the MIN alarm values, the “MIN” touch screen field must be pressed:

-To return to the display for the MAX alarm values, the “MAX” touch screen field must be pressed:

-The individual outdoor sensors can be selected using touch screen fields 4 or 5 as in the normal display mode.

-Programming mode can either be exited immediately by pressing the “END” key (field 28), or automatically 2 minutes after the last key has been pressed. In either case, the unit will revert to normal mode.

-To delete the alarm values, the “RESET ” field (field 26) must be pressed for approx. 3 seconds.

22

Image 22

Contents Touch Screen Wireless Weather Station WS-2510 25-26 Contents27-28 Display of wind speed with wind direction and variation Display of the indoor temperature in F or C and humidityGeneral information and functioning Display of the amount of rainfall in mm, l/m2 or inchesOther Quick overview of the display fields on the main displayPC connection optional Battery operationOperation using the power adaptor Bus connectionPlease note Previous weather sensors with software Version Setting up/Wall mountingCommissioning Outdoor sensors1 WS-2510-15 wind sensor Description, Installation and Commissioning of sensorsInsertion of magnets into the outdoor sensors 2 WS-2510-16 rain sensor7 WS-2510-25 temperature/humidity outdoor sensor 5 WS-2510-22 temperature/humidity sensor6 WS-2510-27 temperature/humidity sensor Brightness sensor WS-2510-19Basic settings, Configuration OperationConfiguration General settings Illumination settingsCleaning mode Wwvb and sensor receptionSetting the temperature display units Illumination time for battery operationIllumination time for AC adaptor operation Setting the rainfall display units Calibration of the rainfall reading indicatorAir pressure display correction Setting the time function Setting the air pressure display unitsSetting the display type for the history trend display Keypad beep on/offPlease note Setting the day and the dateSensor administration Protocol versionNormal display function Key functions Allocation of touch screen fields, seeOutdoor sensors fields 3 to Wind measurement fieldRainfall measurement fields 8/9 Air pressure measurement fields 10/11Weather forecast Brightness Following particular features should be noted Hours of sunshine No key functionsMinimum/Maximum value display Time/DateKey functions Example for the display of maximum valuesDeleting min/max values History display for min/max valuesAlarm values can be set for Programming mode entering alarm valuesProgramming the min/max alarm values Setting/Resetting the MIN/MAX alarm values Setting the wake-up times Please noteAlarm initiation, Alarm reset Display exampleChanging batteries Base station Information on fault removalSensor batteries are discharged Range Maintenance and servicing informationRepeater for range increase Perceived temperature -see Wind chill Technical dataExplanation of terms Wind strength table Beaufort Wind speed Description Warranty Information