Fluke PN 2063508 user manual Measuring Voltage

Page 10

12 Multimeter

MEASURING VOLTAGE

MEASURING VOLTAGE

1.Insert the test leads in the jacks.

2.To select a voltage function, put the slide-switch in the middle position. See Figure 3.

To toggle between dc and ac, press [g].

3.Touch the probes to the test points, and read the display. The meter beeps an Overload Alert™ when OL (overload) is displayed.

In manual range, you can toggle the meter between a high or low input impedance mode by moving the slide-switch between the voltage and continuity/ohms positions. (See “i AND HOW TO USE IT”.) In the continuity/ohms position, the input impedance of the meter is 2 kΩ, and LoZ is displayed to indicate that the meter is in the low input impedance mode. In the volts position, the input impedance is 5 MΩ in ac and 10 MΩ in dc.

7

Image 10

Contents Multimeter Table of Contents Multimeter Read First Safety Information Symbols Display DisplayOperating Features Operating FeaturesStandby Mode Input RangesAutoranging Manually Selecting a RangeMeasuring Voltage Measuring Voltage Testing Continuity and Measuring Resistance Continuity and Resistance Measurements Testing Diodes Testing Diodes Vchek and HOW to USE IT Disabling iWITH Function Lock Measuring Capacitance Measuring Capacitance Using MIN MAX Functions Recording Minimum and Maximum ReadingsDisplaying Minimum and Maximum Reading Recording Minimum and Maximum Reading with Elapsed Time Maximum and Minimum Reading with Elapsed Time Capturing Continuity Intermittents with Continuity Capture Open-to-Short and Short-to-Open Transitions Turning Beeper OFF MaintenanceReplacing the Battery Replacing the Test LeadsService and Parts Accessories SpecificationsTerminal and Earth Ground Multimeter Us rs Manual Continuity Capture