Fluke PN 2063508 user manual Recording Minimum and Maximum Reading with Elapsed Time

Page 22

12 Multimeter

USING MIN MAX FUNCTIONS

Recording Minimum and Maximum Reading with Elapsed Time

The MIN MAX with elapsed-time mode records the time (in hours and minutes) between when MIN MAX was entered and the last high and low was recorded. Time is kept to 99:59. OL is displayed for longer times.

1.To enable the MIN MAX elapsed-time clock, hold [j] down while moving the slide-switch from OFF to the volts or continuity/ohms position.

2.Insert the test leads, and put the meter in volts or ohms.

3.Connect the leads to the circuit.

4.Press [j] to select MIN MAX. j is displayed, and time is set to 00:00.

5.Press [j] to step through the display sequence shown in Figure 8.

6.To exit, press [j] for 2 seconds, or change the measurement function.

19

Image 22

Contents Multimeter Table of Contents Multimeter Read First Safety Information Symbols Display DisplayOperating Features Operating FeaturesStandby Mode Input RangesAutoranging Manually Selecting a RangeMeasuring Voltage Measuring Voltage Testing Continuity and Measuring Resistance Continuity and Resistance Measurements Testing Diodes Testing Diodes Vchek and HOW to USE IT Disabling iWITH Function Lock Measuring Capacitance Measuring Capacitance Using MIN MAX Functions Recording Minimum and Maximum ReadingsDisplaying Minimum and Maximum Reading Recording Minimum and Maximum Reading with Elapsed Time Maximum and Minimum Reading with Elapsed Time Capturing Continuity Intermittents with Continuity Capture Open-to-Short and Short-to-Open Transitions Turning Beeper OFF MaintenanceReplacing the Battery Replacing the Test LeadsService and Parts Accessories SpecificationsTerminal and Earth Ground Multimeter Us rs Manual Continuity Capture