Sanyo KS1251, KS0951, KS1852 Using the Remote Control Unit, How to Install Batteries, Do not

Page 10

Using the Remote Control Unit

How to Install Batteries

ACL button

Cover

1.Slide the cover in the direction indicated by the arrow and remove it.

2.Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment.

3.Use a thin object such as the tip of a pen to press the ACL button.

NOTE

·

·

·

·

The batteries last about six months, depending on how much you use the remote control unit. Replace the batteries when the remote control unit's display fails to light, or when the remote control cannot be used to change the air conditioner's settings.

Use two fresh leak-proof type-AAA alkaline batteries.

In replacing batteries, follow the instructions as mentioned in the sub-section ``How to Install Batteries''.

If you do not use the remote control unit more than 1 month, take out the batteries.

How to Use the Remote Control Unit

When using the remote control unit, always point the unit's transmitter head directly at the air conditioner's receiver.

Air conditioner (Indoor unit)

 

Receiver

Remote control

(Transmitter head)

 

unit

 

Remote Control Unit Installation Position

DO NOT

The remote control unit may be operated either from a non-fixed position or from a wall-mounted position. To ensure that the air conditioner operates correctly, DO NOT install the remote control unit in the following places:

·In direct sunlight

·Behind a curtain or other places where it is covered

·More than 26 feet (8 m) away from the air conditioner

·In the path of the air conditioner's airstream

·Where it may become extremely hot or cold

·Where it may be subject to electrical or magnetic noise

·Where there is an obstacle between the remote control unit and air conditioner (since a check signal is sent from the remote control unit every 5 minutes)

10

OI-330-10EG

Image 10
Contents KS0951 KS1251 KS1852 Features Alert Symbols ContentsProduct Information Safety Instructions Installation LocationElectrical Requirements Indoor Unit Names of PartsOutdoor Unit OFF position does not disconnect the power. Use the main Remote control receiverTimer lamp Operation lamp Remote control receiver Power switch to turn off power completely SET Temp Timer OFF button Temperature settingButton Timer on button TransmitterDRY Remote Control UnitCool How to Use the Remote Control Unit Using the Remote Control UnitHow to Install Batteries Remote Control Unit Installation PositionUsing the Remote Control Unit Mounting the Remote Control UnitManual Operation Operation with the Remote Control UnitStep Adjusting the Fan Speed Operation with the Remote Control UnitFAN Speed Setting Temperature 30 min Press Time Night Setback ModeNight Setback Mode is used for saving energy Cooling and DRYSpecial Remarks Power failure during operation Clicking SoundRemote Control Unit ``DRY OperationTimer OFF mode Example Using the 12-Hour on and OFF TimerTimer on mode Example Setting procedureHour OFF Timer Using the 1-Hour OFF TimerCombining the 1-Hour OFF Timer and 12-Hour on Timer Horizontal Vertical Adjusting the Airflow DirectionSetting the airflow manually Sweep DRY Recommended operating range Sweep functionCare and Cleaning Operation without the Remote Control UnitCasing and Grille Indoor Unit How to replace the anti-mold filter Care and CleaningAnti-mold filter How to remove the anti-mold filter Air intake grilleAir cleaning filter not provided KS0951/KS1251Do · Tips for Energy SavingDo not · Removing and remountingOperating Range TroubleshootingTrouble Possible Cause Remedy Sanyo Canada Inc CanadaSanyo Fisher Company Division of Sanyo North America Corporation
Related manuals
Manual 24 pages 9.78 Kb