Repeat1 Off, PGM1 s01EE, PGM1 s0103, PGM1 s02EE

Section 6 : Playback

6-5. Repeat playback

This function allows one or all programs to be played back repeatedly.

áWith one program repeat, the tape is automatically rewound to the previous Start ID when a Start ID is detected.

áFor all program repeat, the tape is automatically rewound to the beginning when the tape end is reached or the End ID is detected.

1 Select the deck with the SELECT 1/2 key.

2 Press the MENU key to show the following menu in the time display.

Repeat1 Off

3 Set to "Single" with the UP/DOWN key to engage the One Program Repeat mode. Set to "All" to engage the All Program Repeat mode.

ÉIf the STANDBY key is set to ON in the One Program Repeat mode, the Play-Pause mode is engaged at the beginning of the program after one program has been played.

6-6. Program playback

This function allows you to play back programs in a user- specified sequence.

1 Select the deck with the SELECT 1/2 key.

2 Press the MENU key to show the following menu in the time display.

PGM1 s01_EE

3 Enter the program number of the program you want to play first with the UP/DOWN key.

PGM1 s01_03

4 To program the program you want to play back second, first press the > key and set the step number to "s02".

PGM1 s02_EE

5 Enter the program number of the program you want to play back second with the UP/DOWN key.

PGM1 s02_05

6 Up to 50 programs can be programmed in the same way.

7 Press the EXECUTE key to start Program Playback.

ÉThe last step is the step before the step in which "EE" is shown in the program number input section on the menu.

e.g.) In case of [PGM1 s03_EE], step 02 (s02) is the last step.

ÉChecking the programmed sequence

Each time the > key is pressed while the program

menu (e.g.: [PGM1 s01_03]) is displayed, the step number changes, allowing you to check the pro- gram number.

(By pressing the > key while pressing the SHIFT key, you can check the previous step number.)

ÉAdding to or changing the programmed sequence

To add a program number, display the step number with "EE" and enter the program number. Adding a program number in the middle of the program sequence is not possible.

To change the program number, display the program number to be changed by pressing the > key and enter a new program number with the UP/DOWN key.

áTo enter "EE", press the UP key and DOWN key simultaneously or the CLEAR key on the remote control unit.