Section 4 : Features and Controls
0ID-related display
Shows the indication for the deck selected by the SELECT 1/2 key.
START WRT:
Lights when the Start ID Manual Writing mode is selected.
START ERASE:
Lights when Start ID erasing is selected.
SKIP WRT:
Lights when Skip ID writing is selected.
SKIP ERASE:
Lights when Skip ID erasing is selected.
END WRT:
Lights when End ID writing is selected.
RENUM:
Lights when renumbering is selected.
START:
Lights when the Start ID is detected.
SKIP:
Lights when the Skip ID is detected.
END:
Lights when the End ID is detected.
qSampling frequency display
ÉWhen an analog signal is being recorded, the sam- pling frequency (48.0k, 44.1k, 32.0k) selected by the Fs switch is lit.
ÉWhen a digital signal is being recorded, the sam- pling frequency (48.0k, 44.1k, 32.0k) of the input signal is lit.
áWhen "DIGITAL" is selected with the INPUT switch and recording is performed without dig- ital signal input, 48.0k blinks.
ÉLP lights in the Long Play mode.
wPeak level meter
ÉShows the input signal level during
ÉThe playback signal level is shown during play- back.
ÉWhen the input or playback signal level surpasses the
eTime-related display
ABS:
Lights when the ABS time is shown on the time display.
PGM:
Lights when the PGM time is shown on the time display.
REMAIN:
Lights when the REMAIN time is shown on the time display.
rRepeat display
Shows the indication for the deck selected by the SELECT 1/2 key.
REPEAT:
Lights in the
ALL REPEAT:
Lights in the
8COMMON MODE switch
1 & 2:
Select to engage both Deck 1 and Deck 2 in the Record or Play mode at the same time.
1 · 2:
Continuous playback or recording on Deck 1 and Deck 2.
OFF:
For independent operation of Deck 1 and Deck 2.
9Fs switch
ÉWhen recording analog input signals, select the sampling frequency (32k, 44.1k, 48k).
áWhen 32k is selected, the Long Play mode is engaged.
áWhen recording digital input signals, the sam- pling frequency is automatically determined according to the input signals.
0MARGIN RESET key
ÉResets the margin value when pressed while the margin value is shown in the program number/mar- gin display.
áWhen holding this key pressed, the margin value corresponding to each input signal is shown con- tinuously.
ÉShows the margin value for as long as it is pressed, when pressed while the program number is shown in the program number/margin display during play- back.
qINPUT level controls
Use to adjust the recording level.
wSELECT 1/2 key
To select the control deck for Deck 1 and Deck 2 (ID MODE key, EXECUTE key).
When setting the menu, use to select the deck as required.
eANALOG INPUT switch
Set this switch when input signals are analog.
UNCAL:
To adjust the recording level with the INPUT level controls.
CAL:
The input and output levels are fixed and the record- ing level cannot be adjusted.
áFor the specified input level, the level meter shows
rINPUT switch
Set this switch according to input signals.
ANALOG:
Select when input signals are analog.
DIGITAL:
Select when input signals are digital.
11