8.Point the Blast Gun at the workpiece so that the media will strike the surface of the workpiece at about a 45 degree angle.
9.Squeeze the Control Lever (42C) of the Blast Gun to release the media. NOTE: The flow rate of the media may be irregular when the Blast Gun is first started. Provided the media is dry, the flow rate will become normal in approximately one minute. (See Figure E.)
10.Adjust the Abrasive Control Valve (18B) to increase or decrease the media flow rate. (See Figure F.)
11.Adjust the Throttling Valve (18A) to regulate the total air flow and pressure at the Blast Gun. (See Figure F.)
12.Move the Blast Gun in a circular or right to left motion until you have achieved the desired appearance (finish) on the workpiece.
13.Periodically, check the Water Trap (17) for excessive water
14.When the sandblasting job is completed, release pressure on the Control Lever (42C) of the Blast Gun. Turn off the air compressor. Turn the Air Supply Valve (18), Throttling Valve (18A), and Abrasive Control Valve (18B) to the “OFF” position. (See Figure F.)
15.Use the Safety Valve (10) to release any remaining air pressure in the Tank (1).
Check to make sure the Pressure Gauge reads “0” PSI. (See Figures D and F.)
16.Squeeze the Control Lever (42C) of the Blast Gun to release any remaining air pressure and media. (See Figure E.)
17.Disconnect the compressor air hose from the Inlet Connector (19).
(See Figure F.)
18.If necessary, empty the Tank (1) of any remaining media. Then, store the Pressurized Abrasive Blaster in a clean, dry, safe location out of reach of children and other unauthorized people.
INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Prior to performing any inspection, maintenance, or cleaning of the Pressurized Abrasive Blaster, turn off the air compressor. Turn the Air
SKU 95014 | For technical questions, please call | PAGE 12 |