3.Slide a Wheel Washer (51) onto each end of the Wheel Axle (5).
(See Figure B.)
4.Place a Wheel (2) onto each end of the Wheel Axle (5). Then, slide a Wheel Washer (51) onto each end of the Wheel Axle. (See Figure B.)
5.Insert a Cotter Pin (3) through the holes in each end of the Wheel Axle (5). Then, bend the Cotter Pins to secure the Wheels (2) to the Wheel Axle.
(See Figure B.)
6.Roll the Pressurized Abrasive Blaster over so that the Handle Bars (6) are facing down.
7.Align the holes of the Front Foot (4) with the holes in the foot mount on the front side of the Tank (1). (See Figure B.)
8.Insert a Cotter Pin (3) through the holes and bend it to secure the Front Foot (4) in place. (See Figure B.)
To Attach The Abrasive Hose And Blast Gun:
1.IMPORTANT: Make sure to use pipe thread sealer tape (not included) on all threaded joints and ensure all joints are securely tightened.
2.Locate the Abrasive Hose (24), Blast Gun, and two Hose Clamps (23).
3.Slide one Hose Clamp (23) onto each end of the Abrasive Hose (24). Do not tighten yet. (See Figure C.)
4.Slide one end of the Abrasive Hose (24) onto the Hose Adapter (49C) of the
1
BLAST GUN
22
24
49C 23
FIGURE C
SKU 95014 | For technical questions, please call | PAGE 8 |