ASSEMBLY INSTRUCTIONS
To Attach The Handle Bars:
1.To attach the two Handle Bars (6) to the Tank (1), lay the Tank on a flat, level surface with its Handle Bar mounting brackets facing up. (See Figure B.)
2.The Handle Bars (6) are labeled “Left” and “Right”. Align the holes in the left Handle Bar with the Handle Bar mounting brackets on the left side of the Tank
(1). (See Figure B.)
3.Place a Washer (50) onto each of the four Handle Bar mounting Screws (8). Insert a Screw through each of the holes in the Handle Bar and Handle Bar mounting brackets. Then, screw a Hex Nut (9) onto each of the Screws and firmly tighten. (See Figure B.)
4.Repeat Steps #2 and #3 for the right Handle Bar (6) to the Tank (1).
(See Figure B.)
6
8
2
35
50
51
9
1
4
FIGURE B
3
To Attach The Wheels And Front Foot:
1.Locate the two Wheels (2), three Cotter Pins (3), Wheel Axle (5), four Wheel Washers (51), and Front Foot (4).
2.Slide the Wheel Axle (5) through the axle holes located at the bottom of the two Handle Bars (6). (See Figure B.)
SKU 95014 | For technical questions, please call | PAGE 7 |