Graco 800632, Series B Water Sandblasting, Shutdown, Flushing, and Storage, Maintenance Chart

Operation

Water Sandblasting

Water Sandblasting Kit 244766 is available for abrasive cleaning of stubborn dirt and paint. The kit requires a sandblasting tip, sold separately as follows:

D2545 pressure washer uses sandblasting tip 805325.

D3040 pressure washer uses sandblasting tip 805317.

D3235 pressure washer uses sandblasting tip 805313.

Shutdown, Flushing, and Storage

CAUTION

If water freezes in the pressure washer, thaw it in a warm room before you try to start it. Do not pour hot water on or into the pump; it may crack the ceramic plungers!

DIf the pressure washer will be exposed to freezing temperatures, drain all water out of the pump. If it must be stored in freezing temperatures, flush it with a 50% antifreeze solution, and relieve the pressure. Flush the pressure washer before you use it again to remove the antifreeze.

DBefore you store the pressure washer overnight or transport it, disconnect the water supply, and turn off the fuel supply valve.

DAfter each use, wipe all surfaces of the pressure washer with a clean, damp cloth.

DPerform the appropriate maintenance. See Maintenance Chart at right.

Maintenance

Observing regular maintenance intervals helps ensure that you get maximum performance and life from the pressure washer.

There is a break-in period for the engine and pump. After you change the oil in these components following their respective break-in periods, the interval between required changes is longer.

If the pressure washer is operated in dusty conditions, these maintenance checks should be made more often.

Maintenance Chart

		Relieve the pressure
		(see page 5) before you
		proceed with maintenance.
Interval	What to do
Daily	Clean water inlet screen and filter.
	Check engine and pump oil levels.
	Fill as necessary. Check gasoline
	level. Fill as necessary.
After first	Change engine break-in oil. Drain
5 hours of	oil when warm. Use SAE 30 or
operation	10W–30 detergent oil.
After every	Clean and remove air cleaner
25 hours of	foam. Wash with water and
operation	detergent. Dry thoroughly. Rub
	with oil, and squeeze to distribute
	oil.
After first	Change pump break-in oil. Use
50 hours of	SAE 20 or 30 non-detergent oil.
operation
After every	Clean or replace paper air cleaner
100 hours of	cartridge. Tap gently to remove
operation, or	dirt. Change engine oil. Use SAE
every 3 months	30 or 10W–30 detergent oil.
After every	Change pump oil. Use SAE 20 or
500 hours of	30 non-detergent oil.
operation, or
every 6 months

308524 7