Husky 1750 US manual Troubleshooting, Problem Possible Cause Correction

7.0 TROUBLESHOOTING

PROBLEM	POSSIBLE CAUSE	CORRECTION
Motor will not start or stops while	Defective GFCI	Perform GFCI Reset procedure, Sec.
operating		Operator's Manual Section 2.0
	Extension cord length or gauge	Use proper extension cord. See
	incorrect	Operator's Manual Section 2.0
	Loose or disconnected plug	Reconnect plug
	Tripped pressure washer thermal	Allow to cool and restart unit
	switch
	Spray Gun Trigger not operating	Call Customer Service Department
	properly
	Defective Gun	Remove gun aim water stream away
		from electrical source and press
		ON. If machine starts, replace gun
		assembl y by cal l ing C usto mer
		Service Department.
Circuit breaker trips or fuse blown in	Circuit Overload	Check that the circuit is rated 15 amps
fuse box		or greater.
	Extension cord too long or wire size	Use proper extension cord as
	too small	recommended in Operator's Manual
		Section 3.3.
	Nozzle partially blocked	Clean nozzle as instructed in Section 5.2
	Excessive pressure	Clean nozzle as instructed in Section 5.2
Water or oil leaking from bottom of	A small amount of leakage is normal	If excessive leaking occurs call
pump		P o wer wa she r F A I P C ust o me r
		Service Department
Trigger will not move	Spray gun safety lock engaged	Release safety lock
Unit will not stop when trigger is	S p r a y g un t r ig g e r sy st e m no t	Call Customer Service Department
released	operating properly
Motor running but pump not	Faucet closed	Open faucet
building maximum pressure or has
irregular pressure	Water inlet screen clogged	Clean screen. See section 5.4
	Gun and hose failure	Replace gun and hose.
	Kink in garden hose	Straighten hose
	Wand nozzle worn out	Replace spray wand
	Air in pump	Let pressure washer run with gun
		o pen and wand r emo ved until
		steady stream of water is released
	Clogged nozzle	Clean nozzle. See manual Section
		5.2

24