Craftsman 919.769062, D28234 owner manual To Change Oil, Inspect, Cleaning

Page 15

To Change Oil

Drain the engine oil when the engine is warm. Warm oil drains quickly and completely.

1.Turn the fuel valve to the OFF position, 1/4 turn clockwise.

2.Place a suitable container next to the engine to catch the used oil.

3.Remove filler cap/dipstick and drain the oil into the container by tipping the engine toward the oil filler neck.

Oil Filler Neck

Oil Filler

Cap/Dipstick

Upper Limit

Lower Limit

NOTE: Please dispose of used motor oil in a manner that is compatible with the environment. It is recommended to take used oil in a sealed container to your local recycling center or service station for reclamation. Do not throw it in the trash or pour it on the ground or down a drain.

4.With the engine in a level position, fill to the upper limit mark on the dipstick with SAE 10W-30 oil. Engine oil capacity is 0.58 quart (.055 liter). NOTE: Other viscosities shown in the chart in the “To Check Oil” paragraph may be used.

5.Replace the oil filler cap/dipstick securely.

Air Cleaner

A dirty air cleaner will restrict air flow to the carburetor and cause poor engine performance. Inspect the filter each time the engine is operated. Clean the filter more frequently if the engine is operated in very dusty areas.

NOTICE: Operating the engine without a filter, will allow dirt to enter the engine, causing rapid engine wear. This type of damage is not covered under the warranty.

Inspect

1.Press the latch tabs on the top of the air cleaner cover and remove the cover. Check the filter to be sure it is clean and in good condition.

2.Reinstall the filter and air cleaner cover.

 

Air Cleaner Body

 

Filter

Air

 

 

 

 

 

Cleaner

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Cover

 

 

 

 

 

Latch

 

 

 

 

 

Tabs

 

 

 

 

 

Lower

Air

Duct

Tabs

 

 

 

 

 

 

 

Cleaning

1.Tap the filter several times on a hard surface to remove dirt or blow compressed air [not exceeding 30 psi (207kPa, 1.2 kg/cm2] through the filter from the clean side that faces the engine. Never try to brush off dirt. Brushing will force dirt into the fibers.

2.Wipe dirt from the air cleaner body and cover using a moist rag. Be careful to prevent dirt from entering the air duct that leads to the carburetor.

15- ENG

D28234

Image 15
Contents Pressure Washer Table of Contents Specification Chart Model No 919-769062 Pressure WasherEngine Maintenance Instructions Risk of Explosion or FireRisk to Breathing Risk of Chemical Burn Risk to Fluid InjectionRisk of Unsafe Operation Risk of Electrical ShockRisk of HOT Surfaces BOX Contents Assembly Throttle Control Lever Controls engine speed OperationHOW to USE Spray Wand To Adjust PressureTo Shut Down HOW to Apply Chemicals and Cleaning SolventsBefore Starting Maintenance Engine Maintenance TaskEngine Customer Responsibilities TableCleaning To Change OilInspect Clean and Replace Spark Plug PumpWand Engine Preparation StorageProblem Cause Correction Troubleshooting GuideProblem Cause Correction Problemcause Garantía Tabla DE ContenidosRPM del Motor Gráfico DE EspecificacionesNormas DE Seguridad / Definiciones Modelo N 919-769062 Lavadora a presiónRiesgo QUÉ Puede OcurrirCómo Prevenirlo Riesgo DE Inyección DE Fluido Riesgo DE Funcionamiento Inseguro Contenido DE LA Caja Ensamblaje Motor Lavadora a PresiónTerminología DE LA Lavadora a Presión Regulación DE LA PresiónCómo Utilizar LA Varilla Rociadora Procedimiento DE Apagado Cómo Emplear Productos Químicos Y Solventes Para LimpiezaAntes DE Comenzar Mantenimiento Verificación del aceite Tabla DE Responsabilidades DEL Cliente Tarea DEMotor Lavadora a PresiónCambio de aceite InspecciónLimpieza Limpieza y reemplazo de las bujías BombaVarilla Rociadora Preparación del motor AlmacenajeProblema Causa Corrección Guía DE Diagnóstico DE ProblemasContinuación Nada o baja Sello gastado o LE-FOYERMC SU-HOGARSM