Craftsman D28234, 919.769062 owner manual Troubleshooting Guide, Problem Cause Correction

8.Pull engine starter rope slowly several times until antifreeze comes out of high pressure hose connection of pump.

9.Remove short hose from water inlet of pump.

10. Reconnect spark plug wire.

*Windshield washer fluid may also be used

TROUBLESHOOTING GUIDE

PROBLEM		CAUSE		CORRECTION
Engine will not	1.	No fuel.	1.	Add Fuel.
start	2.	Pressure builds up after	2.	Squeeze gun trigger to
		two pulls on the recoil		relieve pressure.
		starter or after initial use.
	3.	Not choked.	3.	Choke engine, place engine
				in the choke position.
	4.	Spark plug wire not	4.	Attach spark plug wire.
		attached.
	5.	Choke lever in the	5.	Move choke to the "No
		"Choke" position on a		Choke" position.
		"hot" engine or an engine
		that has been exposed to
		thermal heat for a long
		period of time.
	6.	Fuel valve closed	6.	Move the fuel valve knob to
				the "Open" position.
No or low	1.	Wand not in high	1.	See How to Use Spray
pressure
		pressure.		Wand paragraph in the
(initial use)				Operation Section.
	2.	Low water supply.	2.	Water supply must be at
				least 5 GPM @ 20 PSI.
	3.	Leak at high pressure	3.	Tighten. Apply sealant tape
		hose fitting.		if necessary.
	4.	Nozzle obstructed.	4.	See Spray Wand
				paragraph in the
				Maintenance section for
				the correct procedure.
	5.	Water filter screen	5.	Remove and clean filter.
		clogged.

D28234 18- ENG