Craftsman 919.670281, D2415 owner manual Service and Adjustments, Carburetor, Nozzle Cleaning

Page 14

SERVICE AND ADJUSTMENTS

Carburetor

The carburetor of your high pressure washer is pre-set at the factory. The carburetor should not be tampered with. If your pressure washer is used at an altitude in excess of 5000 feet consult with your nearest Sears Service Center regarding high altitude set changes.

Engine speed was properly adjusted at the factory and should

require no additional adjustment. Do not attempt to change engine speed. If you believe the engine is running too fast or too slow, take your pressure to a Sears Authorized Service Center for repair and ad- justment.

High engine speeds are dangerous and increase the risk of personal

injury or damage to equipment.

Low engine speeds impose a heavy load on the engine and

could shorten engine life.

Nozzle Cleaning

If the nozzle becomes clogged with foreign materials, such as dirt, excessive pressure may develop. If the nozzle becomes partially clogged or restricted, the pump pressure will pulsate. Clean the nozzle immedi- ately using the nozzle kit supplied and the following instructions.

•Shut off the pressure washer and turn off the water supply.

•Disconnect spark plug wire.

•Pull trigger on gun handle to relieve any water pressure.

•Disconnect the wand from the gun.

•Remove nozzle from the the end of the wand with the 2mm Allen wrench provided.

•Clean the nozzle using the nozzle cleaner provided or a straightened paper clip. Insert into the nozzle end and work back and forth until obstructions is removed.

•Direct water supply into nozzle end to back flush loosened particles for 30 seconds.

•Reassemble the nozzle to the wand. Tighten securely to prevent leaks.

•Reconnect wand to gun and turn on water supply.

•Start pressure washer and place wand into high pressure setting to test.

D24150

14 - ENG

Page 13 Page 15
Image 14
Page 13 Page 15
Contents
Horsepower PSI 2.4 GPM High Pressure Washer Sold by Sears Canada, Inc., Toronto, Ont. M5B2B8Table of Contents Safety Guidelines Definitions Important Safety InstructionsRisk of Unsafe Operation Assembly Parts Bag ContentsRemove Pressure Washer from Carton Tools Required for AssemblyAdjustable wrench Mm Allen wrench supplied Preparing the Pressure Washer for First UseKnow Your High Pressure Washer ChecklistOperation Recoil STARTER- Used for starting the engineEngine Oil Stopping Your Pressure WasherBefore Starting The Engine GasolineTo Start Your Pressure Washer Adjusting Fan Spray How To Use Your Pressure Washer Adjusting Chemical FlowPressure Washer Specifications MaintenanceProduct Specifications Engine SpecificationsPump Maintenance Changing Pump Oil Pressure Washer MaintenanceEngine Maintenance Check Oil Level Purge Pump of Air and ContaminantsChanging Engine Oil Clean Pre-Cleaner and Air Cleaner CartridgeClean and Replace Spark Plug Check Engine Finger Guard/MufflerCarburetor Service and AdjustmentsNozzle Cleaning Engine Preparation StoragePreparing Pressure Washer for Storage Pump PreparationInitial use Engine will not startNo or low pressure Will not draw chemicalsWater leaking at gun/wand No or low pressure afterPeriod of normal use ConnectionIf calling locally, please use one of the following numbers Sold By Sears Canada, Inc., Toronto, Ont. M5B 2B8Guide DE L’UTILISATEUR Vendu par Sears Canada, Inc., Toronto, Ont. M5B 2B8Entretien Table DES MatièresFonctionnement Mesures DE Sécurité Définitions Mesures DE Sécurité ImportantesRisque DE Surfaces Contenu du sac AssemblageContenu de l’emballage Outils requis pour l’assemblage Bien connaître votre Génératrice FonctionnementListe de vérification Huile moteur Arrêt de l’appareil de lavage sous pressionAvant de démarrer le moteur Plus froid ----40F 4C---- plus chaud Synthétique 5W-30Démarrage de l’appareil de lavage sous pression Réglage du jet Utilisation de l’appareil de lavage sous pressionRéglage du débit des produits chimiques Utilisation de savons/produits chimiquesAvant Toutes les Chaque Heures ou Recommandations généralesEntretien Vérification du niveau d’huileEntretien du moteur Entretien de l’appareil de lavage sous pressionEntretien de la pompe changement de l’huile de la pompe Vérification du protecteur et du silencieux du moteur Nettoyage et remplacement de la bougie d’allumageChangement de l’huile moteur Nettoyage de la buse Entretien ET RéglagesCarburateur Entreposage Préparation du moteurAspiré Le moteur ne démarre pasAucune pression ou basse Connexion du pistolet/lance Dutilisation normaleFuite deau au niveau de la PompeGuide DE L’UTILISATEUR Vendu par Sears Canada, Inc., Toronto, Ont. M5B 2B8