Black & Decker BDP2600 Perature inside the pump. The valve will then close, Pressure Adjustments

Bypass Mode: Allows water to re-circulate within pump when the gun trigger is not pulled.

NOTICE: Allowing the unit to run for more than two minutes without the gun trigger pulled could cause over- heating and damage to the pump.

Thermal Relief Valve: When the temperature inside the pump rises too high the valve will open and release a gush of water in an effort to lower the tem-

perature inside the pump. The valve will then close.

Chemical Injection System: Mixes cleaners or cleaning solvents with the water to improve cleaning effectiveness.

Water Supply: All pressure washers must have a source of water. The minimum requirements for a water supply are 20 psi and 5 gallons per minute.

Pressure Washer

Operating Features

Pressure Adjustments

The pressure setting is preset at the fac- tory to achieve opti­mum­ pressure­ and cleaning. If you need to lower the pres­ sure, it can be accomplished by these methods­.

1.Back away from the surface­ to be cleaned. The further away you are, the less the pressure will be on the surface to be cleaned.

2.Change to the 40º nozzle - (white) this nozzle delivers a less powerful stream of water and a wider spray pattern.

NOTICE: DO NOT attempt to increase pump pressure. A higher pressure setting than the factory set pressure may damage pump.

Spray Wand Nozzles

The nozzles for the spray wand are stored in the nozzle holder on the panel assembly. Colors on the panel identify nozzle location and spray pattern. Refer to the following chart to choose the cor- rect nozzle for the job to be performed.

Changing Nozzles on Spray Wand

DANGER: Risk of fluid injec- tion. Do not direct discharge stream toward persons, unprotected skin, eyes or any pets or animals. Serious injury will occur.

WARNING: Flying objects could cause risk of serious injury. Do not attempt to change nozzles while pressure washer is running. Turn engine off before changing nozzles.

Nozzle Color	Spray Pattern	Uses	Surfaces*
	0˚	powerful pinpoint	unpainted metal or
Red		for spot cleaning	concrete;
		of hard, unpainted	DO NOT use on wood
		surfaces or for high
		reach areas
	15˚	intense cleaning	grills, driveways, concrete
Yellow		of unpainted hard	or brick walkways,
		surfaces	unpainted brick or stucco
	40˚	cleaning of painted	Auto/RV, marine, wood,
White		or delicate surfaces	painted brick and stucco,
			vinyl, painted siding
	low pressure	applies cleaning	Low pressure spray is safe
Black		solutions	on all surfaces. Always
			verify compatibility of
			cleaning solution prior to
			use.

10- ENG­