Briggs & Stratton 020227-0 How to Stop Your Pressure Washer, How to Use the Adjustable Nozzle

Page 9
How to Stop Your Pressure Washer

SpeedClean™ 2400 PSI Pressure Washer

8.Start engine according to instructions given in engine owner’s manual. Also see operating instructions tag located on the pressure washer.

How to Use the Adjustable Nozzle WARNING

Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go.

Broken bones, fractures, bruises or sprains could result.

•When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback.

•If engine starts and fails to continue to run or if increased resistance is felt during starting pull attempts, squeeze trigger on spray gun.

NOTE: Always keep the throttle lever in the “Fast” position when operating the pressure washer.

Manual background WARNING

Running engines produce heat.Temperature of muffler and nearby areas can reach or exceed 150°F (65°C).

Severe burns can occur on contact.

Combustible debris, such as leaves, grass, brush, etc. can catch fire.

•DO NOT touch hot surfaces.

•Allow equipment to cool before touching.

•The pressure washer must be at least 5 feet from structures having combustible walls and/or other combustible materials.

•Keep at least 3 feet of clearance on all sides of pressure washer for adequate cooling, maintenance and servicing.

•In the State of California a spark arrester is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. If you equip the muffler with a spark arrester, it must be maintained in effective working order.

How to Stop Your Pressure Washer

1.Let engine idle for two minutes.

2.Turn engine off according to instructions given in engine owner’s manual.

3.Squeeze trigger on spray gun to relieve trapped pressure in hose to avoid injury.

NOTE: A small amount of water will squirt out when pressure is released.

Manual background WARNING

The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation.

Spray gun retains high pressure when pressure washer is shut down, which can cause injury.

•Keep high pressure hose connected to pump and spray gun while system is pressurized.

•Squeeze trigger on spray gun to relieve trapped pressure, every time you stop engine. Engage trigger lock on spray gun.

4.Engage trigger lock on spray gun when not in use.

How to Use the Adjustable Nozzle

You should now know how to START and STOP your pressure washer.The information in this section will tell you how to adjust the spray pattern and to apply detergent or other cleaning chemicals.

Manual background CAUTION

A pressure washer produces a high pressure spray which increases risk of injury and damage to unit.

•NEVER adjust spray pattern when spraying.

•NEVER put hands in front of nozzle to adjust spray pattern.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents JEFFERSON,WISCONSIN, U.S.A BRIGGS & STRATTON POWER PRODUCTS GROUP, LLCCall Pressure Washer Helpline Llame Línea Directa del Lavador a Presión - 1-800-743-4115 M-F 8-5 CTSAFETY RULES TABLE OF CONTENTSHazard Symbols and Meanings EQUIPMENT DESCRIPTIONDANGER Spray contact with electrical wiring can result in electrocutionBreathing carbon monoxide will cause nausea, fainting or death Use of pressure washer can create puddles and slippery surfacesCombustible debris, such as leaves, grass, brush, etc. can catch fire Severe burns can occur on contactUnintentional sparking can result in fire or electric shock High pressure spray may damage fragile items including glassSiphon/Filter KNOW YOUR PRESSURE WASHERCarton Contents ASSEMBLYPREPARING PRESSURE WASHER FOR USE Remove Pressure Washer From CartonAdd Engine Oil and Fuel Checklist Before Starting EngineConnect Hose and Water Supply to Pump Figure 6 - Connect the Garden Hose to Water InletHow to Start Your Pressure Washer HOW TO USE YOUR PRESSURE WASHERPressure Washer Location Pressure Washer ClearanceHow to Use the Adjustable Nozzle How to Stop Your Pressure WasherApplying Detergent with the Adjustable Nozzle You must attach all hoses before you start the engineTo apply detergent, follow these steps Automatic Cool Down System Pressure Washer RinsingThermal Relief For RinsingGENERAL MAINTENANCE RECOMMENDATIONS SPECIFICATIONSPRESSURE WASHER MAINTENANCE Check and Clean Inlet ScreenCheck In-Line Filter Nozzle MaintenanceTo remove contaminants from the pump, follow these steps OrificeO-Ring Maintenance ENGINE MAINTENANCECleaning Chemical Injection Hose Pump MaintenanceSTORING THE ENGINE PREPARING THE UNIT FOR STORAGEProtecting the Pump You must protect your unit from freezing temperaturesProblem TROUBLESHOOTINGPump has following problems pressure, low water volumeWARRANTY PERIOD LIMITED WARRANTYABOUT YOUR WARRANTY OUR EQUIPMENTDESCRIPCIÓN DEL EQUIPO TABLA DE CONTENIDOSREGLAS DE SEGURIDAD ADVERTENCIAComo resultado, podrían producirse fracturas, contusiones o esguinces PELIGROLa gasolina y sus vapores son extremadamente inflamables y explosivos CUANDO AÑADA COMBUSTIBLEQuemaduras severas pueden ocurrir al hacer contacto PRECAUCIÓNLos residuos como hojas, hierba, maleza, etc. se pueden inflamar CUANDO AJUSTE O HAGA REPARACIONES A SU MÁQUINA LAVADORA DE PRESIÓNCalcomanía Ejemplar de Datos no mostrado, el trasero CONOZCA SU MAQUINA LAVADORA DE PRESIONPREPARANDO EL LAVADOR A ALTA PRESIÓN PARA SU USO MONTAJERemueva el Lavador a Presión del Empaque Contenido de la CajaConecte la Manguera y el Suministro de Agua a la Bomba Agregar Aceite al Motor y GasolinaLista de Revision Previa al Arranque del Motor Figura 22 - Conectar la Manguera del Jardín a la Entrada de AguaUbicación del Lavadora a Presión CÓMO USAR SU MÁQUINA LAVADORA A PRESIÓNCómo Darle Arranque a su Máquina Lavadora a Presión Espacio Libre Alrededor del Lavadora a PresiónCómo Usar la Boquilla Ajustable Cómo Detener su Máquina Lavadora a PresiónFigura 26 - Ajustar la Presión de Aspersión Figura 27 - Poner a Prueba el Patrón de AspersiónEnjuage de la Máquina Lavadora a Presión Aplicación del Detergente Usando la Boquilla AjustableSistema de Enfriamiento Automático Alivio Térmico Figura 28 - Ajustar el Patrón de AspersiónRECOMENDACIONES GENERALES ESPECIFICACIONESMANTENIMIENTO DE LA MAQUINA LAVADORA A PRESION Antes de Cada UsoMantenimiento de la Boquilla Revise el Filtro en LíneaPara retirar los contaminantes de la bomba, siga los siguientes pasos Figura 30 - Remover y Limpiar la BoquillaMantenimiento de los Anillos O MANTENIMIENTO DEL MOTORLimpiando el Tubo Mantenimiento de la BombaALMACENANDO EL MOTOR PREPARANDO LA UNIDAD PARA SU ALMACENAMIENTOProteger la Bomba Usted deberá proteger su unidad de las temperaturas de congelamientoProblema REPARACION DE AVERIASproblemas no produce presión volumen de aguaNUESTRO EQUIPO GARANTÍA LIMITADAPERÍODO DE GARANTÍA ACERCA DE LA EQUIPO GARANTÍA
Top Page Image Contents