Briggs & Stratton 01937 Engine Maintenance, Preparing Unit for Storage, Storing the Engine

Page 14

2800 PSI Pressure Washer

ENGINE MAINTENANCE

See the engine owner’s manual for instructions on how to properly maintain the engine.

CAUTION

Avoid prolonged or repeated skin contact with used motor oil.

•Used motor oil has been shown to cause skin cancer in certain laboratory animals.

•Thoroughly wash exposed areas with soap and water.

4.Empty pump of liquids by pulling engine recoil handle about 6 times.This should remove most liquid from pump.

5.Use pump saver to prevent corrosion build up and freezing of pump.

6.Store unit in a clean, dry area.

Protecting the Pump

To protect the pump from damage caused by mineral deposits or freezing, use PumpSaver to treat pump.This prevents freeze damage and lubricates pistons and seals.

KEEP OUT OF REACH OF CHILDREN. DON'T POLLUTE. CONSERVE RESOURCES. RETURN USED OIL TO COLLECTION CENTERS.

PREPARING UNIT FOR STORAGE

Water should not remain in the unit for long periods of time. Sediments or minerals can deposit on pump parts and “freeze” pump action. If you do not plan to use the pressure washer for more than 30 days, follow this procedure:

1.Empty all chemical reservoirs as follows:

a.Disconnect hose connected to chemical inject fitting on pump. Place end of hose into suitable container.

b.Rotate one of the chemical shut-off valves to “On” position and open that tanks cover. Gravity will empty tank contents into container.

c.When first tank is empty, repeat step (b) for other tank, using a different container.

d.Reconnect hose to chemical inject fitting on pump. Add 0.5 liter of clean fresh water to each tank and close tanks covers.

2.Flush chemical system by selecting one tank, turning its chemical shut-off valve to “On” position and run pressure washer with black spray tip. Flush until first tank is empty.Turn its chemical shut-off valve to “Off” position. Flush other tank the same way.

3.Shut off engine and let it cool, then remove high pressure and garden hoses. Disconnect spark plug wire from spark plug.

NOTE: PumpSaver is available as an optional accessory. It is not included with the pressure washer. Contact the nearest authorized service center to purchase PumpSaver.

CAUTION

You must protect your unit from freezing temperatures.

•Failure to do so will permanently damage your pump and render your unit inoperable.

•Freeze damage is not covered under warranty.

CAUTION

Read and follow all cautions and warnings on the PumpSaver can label.

• Always wear eye protection when using PumpSaver.

To use PumpSaver, make sure the pressure washer is turned off and disconnected from supply water. Read and follow all instructions and warnings given on the PumpSaver container.

NOTE: PumpSaver will drip from pump after treatment and will stain wood and concrete.

NOTE: If PumpSaver is not available, draw RV antifreeze (non-alcohol) into the pump by pouring the solution into a 3-foot section of garden hose connected to inlet adapter and pulling recoil handle twice.

STORING THE ENGINE

See the engine owner’s manual for instructions on how to properly prepare the engine for storage.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents 01937 2800 PSI Equipment Description Table of ContentsSafety Rules When Adding or Draining Fuel High pressure spray may damage fragile items including glass Choke Lever Safety Goggles not shown Always use the enclosedKnow Your Pressure Washer Recoil StarterPreparing Pressure Washer for USE AssemblyCarton Contents Remove Pressure Washer From CartonAdd Engine Oil and Fuel Attach Hose ReelAttach Chemical Reservoirs Inspect inlet Checklist Before Starting EngineConnect Hose and Water Supply to Pump Screen, doWasher HOW to USE PressureHow to Stop Your Pressure Washer To Start Your Pressure WasherLow Pressure How to Use Spray TipsCleaning and Applying Chemical High PressureAutomatic Cool Down System How to Use the Hose ReelPressure Washer Rinsing Thermal ReliefPressure Washer Maintenance SpecificationsGeneral Maintenance Recommendations Purge Pump of Air Contaminants Nozzle MaintenanceRing Maintenance To remove air from the pump, follow these stepsPreparing Unit for Storage Engine MaintenanceAlways wear eye protection when using PumpSaver Storing the EngineTroubleshooting Problem Cause CorrectionItems Not Illustrated Description Exploded View and Parts List UnitDescription Exploded View and Parts List Pump PSI Pressure Washer Consumer Use Years Years or YearInstrucciones DE Seguridad Tabla DE ContenidosDescripción DEL Equipo AdvertenciaPeligro Cuando Añada Combustible O Vacíe EL DepósitoPrecaución Entrada de Agua Conexión para la manguera de jardín Conozca SU Maquina Lavadora DE PresionToma de Alta Presión Entrada de Agua Perilla del Cebador Usada para arranque de motores fríosRemueva el Lavador a Presión del Empaque MontajePreparando EL Lavador a Presión Para SU USO Contenido de la CajaAgregar Aceite al Motor y Gasolina Montaje del Carretel de MangueraMontaje de Depósitos de Productos Químicos Gancho del PistolaDeposite la gasolina adecuada en el tanque del combustible Conecte la Manguera y el Suministro de Agua a la BombaLista de Revision Previa al Arranque del Motor Proporcione el suministro de agua adecuadoCómo Detener su Lavadora a Presión Cómo Usar SU Lavadora a PresiónCómo Darle Arranque a su Lavadora a Presión La Presión Alta Cómo Usar las Puntas de RociadoLa Presión Baja Limpieza y Aplicación del QuímicoSistema de Enfriamiento Automático Alivio Térmico Enjuage de la Máquina Lavadora a PresiónCómo Usar el Carrete de la Manguera Coloque el cerrojo de seguridad a la pistola de rociadoAntes de Cada Uso EspecificacionesRecomendaciones Generales Mantenimiento DE LA Lavadora a PresionMantenimiento de la Boquilla Mantenimiento DEL MotorElimine el Aire y los Contaminantes de la Bomba Mantenimiento de los Anillos OProteger la Bomba Preparando LA Unidad Para SU AlmacenamientoAlmacenando EL Motor Almacene la unidad en un lugar limpio y secoNotas Notas Reparacion DE Daños Garantía Limitada
Top Page Image Contents