2800 PSI Pressure Washer
2.Insert carriage bolts through holes from outside of unit and attach plastic knob from inside of unit (Figure 2). Tighten by hand.
Figure 2 — Secure Handle
3.Insert “L” bolt through hole just above billboard on left side of handle (viewing from front of unit). Hold hook in place and attach plastic knob from inside of unit (Figure 3).Tighten by hand.
Figure 3 — Attach “L” Bolt to Handle
Spray Gun Hook
2.Attach chemical hose to chemical injection fitting on pump (Figure 5).
Figure 5 — Attach Chemical Hose to Chemical Injection |
Fitting on Pump |
Attach Hose Reel
1.Install hose reel on handle, as shown on page 5, according to the instructions provided with hose reel.
NOTE: There may be small tube adapters included with the hose reel kit that is not used on this model.
IMPORTANT: You must take the hose off the reel when operating your pressure washer.The reel is for hose storage purposes only.
Attach Chemical Reservoirs
1.Use a 5/16” nut driver to attach chemical reservoir assembly to handle with four black self tapping screws in holes provided (Figure 4).
Figure 4 — Attach Chemical Reservoir Assembly to Handle
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.
•Refer to engine manual for oil and fuel fill information.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
•Refer to engine owner’s manual and follow oil and fuel recommendations and instructions.
NOTE: Check oil often during engine
7