Zenoah PSZ2500 manual If Someone Comes, Maintenance

Page 10

5. For safe operation

• IF SOMEONE COMES

1.Guard against hazardous situations at all times. Warn adults to keep pets and children away from the area. Be careful if you are approached. Injury may result from flying debris.

2.If someone calls out or otherwise interrupts you while working, always be sure to turn off the engine before turning around.

MAINTENANCE

1.In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals.

2.Always be sure to turn off the engine before performing any maintenance or checking procedures.

WARNING

The metallic parts reach high temperatures immediately after stopping the engine.

3.When replacing any part, or when replacing the oil or any lubricant, always be sure to use only

RedMax products or products which have been certified by RedMax for use with the RedMax product.

4.In the event that any part must be replaced or any maintenance or repair work not described in this manual must be performed, please contact a representative from the store nearest RedMax authorized servicing dealer for assistance.

5.Do not use any accessory or attachment other than those bearing the RedMax mark and recommended for the unit.

6.Under no circumstances should you ever take apart the product or alter it in any way. Doing so might result in the product becoming damaged during operation or the product becoming unable to operate properly.

10

Image 10
Contents PSZ2500 848-A52-93A1Safety First ContentsParts location SpecificationsPSZ2500 Avertissement Symbols on the machine Important Engine InformationWorking Condition For safe operationWorking Circumstance Working Plan Before Starting the Engine Starting the EngineUsing the Product Maintenance If Someone ComesHandling Fuel TransportationBeware of kickback Kickback and Pinching Safety PrecautionsBeware of pinching  13  Set up Pay attention to the correct direction of the saw chain Chain tension adjusting screw Loosen TightenSE4 SE5 SE6 SE7 Hole Moving direction Chain tensioner nutSE8 Balance UnitFuel and chain oil HOW to MIX FuelRecommended Mixing Ratio Gasoline 50OIL For Your Engine LIFE, Avoid Fueling the UnitChain OIL OP33 OP4 OperationOP1 OP2 OP5 Starting EngineChecking OIL Supply Adjusting OIL Flow RateOP6 Stopping Engine OP4 Chain oilOP7 OP8 Adjusting Throttle CableAdjusting Idling Speed OP9 OP9MA1 MA2 MA3 Oiling Port MaintenanceMaintenance Chart Guide BARSprocket MA4 MA5 MA6SAW Chain MA7 MA8 AIR Filter MA9Gear Case Fuel FilterTightening Torque Muffler Replacement Plug is a NGK CMR7ASpark Plug Spark ArresterIntake AIR Cooling Vent Procedures to be Performed After Every 100 Hours of USEMA141 MA15 Cylinder Intake air cooling vent backStorage Troubleshooting guideCheck Probable Causes Action Parts list  30   31   32   33  Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC