Zenoah PSZ2500 manual Parts list

Page 29

12. Parts list

POLE SAW

PSZ2500

NOTE :

1.Use KOMATSU ZENOAH genuine parts as specified in the parts list for repair and/or replacement.

2.KOMATSU ZENOAH does not warrant the machines, which have been damaged by the use of any parts other than those specified by the company.

3.When placing parts orders for repair and/or replacement, check if the model name and the serial number are applicable to those specified in the parts list, then use parts number described in the parts list.

4.The contents described in the parts list may change due to improvement.

5.The parts for the machine shall be supplied seven (7) years after the machine is discontinued. [It is possible that some specific parts may be subject to change of their delivery term and list price within the limit of seven (7) years after the machine is discontinued. It is also possible that some parts may be available even after the limit of seven (7) years.]

APPLICABLE SERIAL NUMBERS :

Dec. 2003

DRIVE UNIT 000000 and up CUTTING UNIT 000000 and up

ENGINE UNIT 50100000 and up

 

 

29

Image 29
Contents 848-A52-93A1 PSZ2500Contents Safety FirstPSZ2500 SpecificationsParts location Avertissement Important Engine Information Symbols on the machineWorking Circumstance For safe operationWorking Condition Working Plan Starting the Engine Before Starting the EngineUsing the Product If Someone Comes MaintenanceTransportation Handling FuelBeware of pinching Kickback and Pinching Safety PrecautionsBeware of kickback  13  Set up SE4 SE5 SE6 SE7 Chain tension adjusting screw Loosen TightenPay attention to the correct direction of the saw chain Hole Moving direction Chain tensioner nutBalance Unit SE8Recommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel and chain oil Chain OIL Fueling the UnitFor Your Engine LIFE, Avoid OP1 OP2 OperationOP33 OP4 OP5 Starting EngineOP6 Stopping Engine OP4 Adjusting OIL Flow RateChecking OIL Supply Chain oilAdjusting Idling Speed OP9 Adjusting Throttle CableOP7 OP8 OP9Maintenance Chart MaintenanceMA1 MA2 MA3 Oiling Port Guide BARSAW Chain MA4 MA5 MA6Sprocket MA7 MA8 Gear Case MA9AIR Filter Fuel FilterSpark Plug Replacement Plug is a NGK CMR7ATightening Torque Muffler Spark ArresterMA141 MA15 Procedures to be Performed After Every 100 Hours of USEIntake AIR Cooling Vent Cylinder Intake air cooling vent backCheck Probable Causes Action Troubleshooting guideStorage Parts list  30   31   32   33  Limited Warranty RedMax Garantie limitée Komatsu Zenoah America INC